10. What is the net section area of steel plate 40cm wide and 10mm thick with one bolt if diameter of bolt hole is 18mm? a) 38.2 cm² b) 24 cm² c) 578 mm² d) 465 mm²

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A:

Q: 5.3 Magnitude of effective length of compression member depends upon A) ocation where member is used…

A:

Q: Given that the three bars shown in the accompanying figure are made of the same material, comparing…

A: Given data- The given bars and their conditions have been shown below-

Q: Question 2: Locate the X-X and Y-Y centroidal axes for the built-up structural steel areas shown.…

A: Centroid: The point at which the given plane figure is divided into equal volumes into all sides is…

Q: 5.1 What is steel tension member? A) Structural elements that are subjected to indirect tensile…

A:

Q: Pu 2. A 12mmx400mm steel plate has staggered holes arranged as shown. "b" 100mm 100mm 100mm 60 mm…

A:

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A:

Q: Answer in this format. Sketch: Given: Required: Solution: (Please answer in detailed (step by step).…

A: The given figure is shown below:

Q: Figure -20 mm y 10 mm Part A Locate the centroid y of the cross-sectional area of the beam…

A: a = 350 mm b = 370 mm

Q: For the objects shown on the left below with an indicated cutting plane. Circle the letter…

A: To select the correct option for the given figure with section shown on the left side.

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A:

Q: Determine the tensile capacity of a 200 x 100 x 12 mm angle in S275 steel assuming that the angle is…

A: 200 x 100 x 12 mm angle S275 steelM24 bolts (3 bolts in a row and p = 70 mm)

Q: D) 5.4 The design bending strength of laterally supported beams is governed by A) yield stress B)…

A: Given data for question 5.4 The design strength of laterally supported beam is governed by ?

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.