10 50 40 Liquid (brine) 30 Salt 20 Ice - 10 liquid (brine) 10 liquid (brine) -20 - 10 Ice + salt -30 -20 NaCI 10 30 H2O 100 90 70 FIGURE P2.33 Composition, weight % Temperature, °C т Temperature, °F

Q: What is the Henry’s law constant in dimensionless form and atmospheres for a compound that has a…

A: Henry's law: At a constant temperature, the amount of a given gas dissolved in a given type and…

Q: An aluminum pipe has a length of 65 m at a temperature of 16°C. An adjacent steel pipe at the same…

A: Given Data:Aluminum pipe has Length Lc=65mTemprature = 16°CCoefficient of thermal expansion steel…

Q: water steel a block b mercury: SG = 13.36

A:

Q: Given: A big hollow cube with side L (ft) =2.41 Inside the big hollow cube, there are small solid…

A: given  side of hollow of cube = 2.41 ft small cube side = 2.67 in total number of cube = 414

Q: Cobalt crystallizes in a HCP unit cell. Its atomic radius is 0.1253 nm. Its density is 8,900 kg/m.…

A: It is required to determine the volume of HCP unit cell. V=242r3 Here r is the atomic radius.…

Q: Communicate the steps during the titration of a weak base with a strong acid. Explain the major…

A: Whenever we titration weak base with strong acid. Phenolphthalein is good indicator. Ph is lies some…

Q: Chlorine gas (7 mg/1 as Cl,) was added to water sample. The free residual chlorine and pH are 2 mg/1…

A:

Q: What are the various parameters that affect the viscosity of a polymer melt, and how do they affect…

A: Polymer melts may be defined as the solutions that are highly viscous liquids, possessing…

Q: The temperature of a bar is reduced by 50°C. If the recorded elongation is -0.5 mm and the…

A:

Q: 2. In a copper-nickel system as shown in figure, an alloy composition of 35 wt% Ni was cooled down…

A:

Q: It is seen that solids and liquids will have different coefficients of volume expansions for…

A: Coefficient of volume expansion:- The unit increase in the unit volume of any substance following…

Q: (a) Determine the equation of the estimated regression line. (Round all numerical values to four…

A: efficiency for a steel specimen immersed in a phosphating tank is the weight of the phosphate…

Q: www (pH=7). What is the total hardness (TH) of water that contains the following ion concentrations…

A: Given:Required:Total hardness of water

Q: Draw a bar diagram on your sketch paper based on the table below and determine the non-carbon…

A:

Q: Why the strength of metal will decrease and ductility increase when increases the temperatures while…

A: Why the strength of metal will decrease and ductility increase when increase the temperature while…

Q: The structure of a material can respond to the disturbance of a thermal or mechanical stimulus…

A: Polymorphism is the existence of material in more than one forms or crystal structure. This is more…

Q: C/ Bismuth (Bi) was melted at 2710C and tin (Sn) was melted at 2320C. Bismuth and ten are formed a…

A: Consider these points 1.) At eutectic point, liquid transform into two different solid states on…

Q: Explain about the reaction mass in the statnamic test.

A: The statnamic test is the tests which are used for determining load carrying capacity of deep…

Q: If the Ksp of Sn(OH)2 (s) is 5.33 x 10-27, what is the solubility of it in the unit of mg/L?

A: Apply formula for solubility  We will find solubility in mol/L from formula Then we have to convert…

Q: A liquid has inb viscosity?

A: PROPERTIES OF FLUID

Q: An aluminum cup of 150 cm³ capacity is completely filled with glycerin at 16°C. How much glycerin…

A: V=150cm3 T2=39oC T1=16oC

Q: gel pores and capillaries decrease with the progress of 5 points cement hydration * True False…

A: Finding out given statement are true or false.

Q: An aluminum pipe has a length of 50 m at a temperature of 6°C. An adjacent steel pipe at the same…

A: Concept   Initial length = L1 at temperature T1  Due to temperature change to T2 length of the…

Q: Determine whether the crystal structure of Metal X is BCC, FCC, or simple cubic.

A: solid structure:

Q: Particle A lies on the x-y plane and is acted on by the three forces shown. Find the resultant of…

A:

Q: Question 2: True or False? Please give simple reason for each of them. (1) Diffusion is a time and…

A: (1) True. Diffusion is a time and temperature-dependent phenomenon by atomic transport. Diffusion…

Q: A metal body floats at the interface of water and oil (sp. gr = that 35% of its volume is submerged…

A:

Q: determine the number of sheets of roof decking required to cover a roof that is 180 ft by 90 ft if…

A: Roof size- 180 ft by 90ft Sheet size- 42ft by 3ft 3 inch  Decking length - 42 ft  Lapping length -2…

Q: Q2: -Determine the center of the mass of the solid block shown in figure below. The density are…

A: Mass=Density×volumem=P×Vx¯=∑mixixi¯∑MiTriangle 1=P×12×1.8×1.5m1=P×1.35

Q: Explain which kind of microstructures you expect to observe at room temperature if an iron-carbon…

A: Microstructures are material structures that may be seen at the microscopic level. They are…

Q: Assumptions: • Density of Al Cu phase is 4.34 g/cm3 • Density of alpha phase is 2.8 g/cm3 • Assume…

A: :The bulk composition of the unknown sample cannot be determined using the lever rule method and the…

Q: A steel rod is 3.425 cm in diameter at 21.00°C. A brass ring has an interior diameter of 3.421 cm at…

A:

Q: An aluminum pipe has a length of 75 m at a temperature of 18°C. An adjacent steel pipe at the same…

A:

Q: Thermal mass refers to materials have the capacity to generate thermal energy for extended periods…

A: Select True or False

Q: Calculate DOl and identify the following structure as determinate,

A: DOI HAS TO CALCULATE OF THE FRAME GIVEN

Q: The viscosity of liquids will increase if the temperature is increased.

A: The  viscosity of fluid is due to cohesion between the molecules . With increase in temperature the…