1. Two uniform thin disks are bolted together with rope wrapped around each of them with weights attached to the end of each rope. Knowing the system is released from rest, determine the rpm (revolutions per minute) of the conjoined disks and which direction they will spin after 10s. A = 8 in, r³ = 6 in. A C 15 lb O B o O O D 18 lb

1. Two uniform thin disks are bolted together with rope wrapped around each of them with weights attached to the end of each rope. Knowing the system is released from rest, determine the rpm (revolutions per minute) of the conjoined disks and which direction they will spin after 10s. A = 8 in, r³ = 6 in. A C 15 lb O B o O O D 18 lb

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A, B, C and D are the four masses carried by a shaft in this order. Radii of rotation of the masses are 20cm, 25 cm, 10 cm and 15 cm respectively. The masses of B, C and D are 3 kg, 5 kg and 4 kg respectively.The planes containing B and C are 25 cm apart. Angle between B and C is 90o and between B and D is220o measured in anticlockwise direction. For complete dynamic balance, find (i) The mass and angularposition of A, (ii) The position of planes A and D.
A 5.32-kg disk A of radius 0.445 m initially rotating counter-clockwise at 436 rev/min is engaged with a 6.72-kg disk B of radius 0.275 m initially rotating clockwise at 528 rev/min, where the moment of inertia of a disk is given as I = ½ mi?. Determine their combined angular speed (in rpm) and direction of rotation after the meshing of the two disks. Remember to show clearly the equations that you use!!'
A machine shaft running at an average speed of 360 r.p.m requires a constant torque of 1.5 kN-m during two revolutions and a constant torque of 400 N-m during next three revolutions and this cycle repeats. Determine the power of the motor required and moment of inertia of a flywheel in order that the total fluctuation of speed shall not exceed 6 percent of mean speed of 320 r.p.m.
The rotor of a gas turbine is turning at a speed of 5,600 rpm when the turbine is turned off. It is observed that it takes 5 min for the rotor to come to rest. Assuming that the motion is uniformly accelerated, determine the angular acceleration of the rotor.
A 240-lb block is suspended from an inextensible cable which is wrapped around a drum of 1.25-ft radius rigidly attached to a flywheel. The drum and flywheel have a combined centroidal moment of intertia of 10.5 lb-ft-s^2. At the instant shown, the velocity of the block is 6 ft/s directed downward. The bearing at A as a frictional moment of 60 lb-ft. What is the kinetic energy of the system after the block moved after 4ft? (in ft-lb)
The four bar linkage in Fig. 2 is driven by link 2 at constant angular velocity of 300rpm ccw. Determine angular velocity of link 3, absolute velocity of point E and C when B=30° 25 mm A B B 110 mm. 100 mm. Fig. 2 40 mm 65 mm D E A
A cylinder rolls without slipping between two moving plates C and D. The radius of the cylinder is r=4.0m. The velocity of the plate C is VC=6.0 m/s to the right. The velocity of the plate D is VD=2.0 m/s to the left. Using the instantaneous center of zero velocity (IC) to determine (2) The distance between point B and IC point, rB/IC=_____ m
Only need A, B, and C please.
The cylinder B rolls on the fixed cylinder A without slipping. Point C is a fixed point. (Figure 1) Figure 0.1 m с' @CD 0.3 m B Part A transcript If connected bar CD is rotating with an angular velocity WCD= 5.5 rad/s, determine the angular velocity of cylinder B measured counterclockwise. Express your answer using three significant figures. Enter positive value if the angular velocity is counterclockwise and negative value if the angular velocity is clockwise. WB = Submit Provide Feedback ΑΣΦΑ Request Answer ↓1 ves 8222 ? rad/s Next >
A drum can rotate about a fixed-point O. The A block is attached to a cord wrapping around the drum. The mass of the drum is md = 100kg and the radius is r = 0.5 m. The radius of gyration of the drum about point O is ko=0.3 m. The mass of the block is mb= 20kg. The block is released from rest. The acceleration due to gravity is g=9.81 m/s2. (1) Calculate the mass moment of inertia of the drum about the point O, IO_______(kgm2) (two decimal places)
A drum of radius r1 = 3 in. is mounted on a cylinder of radius r2 = 6 in. A cord is wound around the drum, and its extremity D is pulled to the left with a constant velocity of 6 in./s, causing the cylinder to roll without sliding. Determine: 1. The angular velocity of the cylinder. 2. The velocity of the center of the cylinder A. Select one: A. ω=6 rad/s; and VA = 30 in/s. B. ω=4 rad/s; and VA = 16 in/s. C. ω=5 rad/s; and VA = 25 in/s. D. ω=2 rad/s; and VA = 6 in/s.
Please answer this in 20 mins