Two identical slender rods AB and BC (MAB = MBC = 1.5 kg) are welded together to form an L shaped assembly. The assembly is pressed against a spring at D and released from the position shown (Position 1). The assembly then passes through the position where rod AB forms an angle of 60° counterclockwise from the horizontal (Position 2). Knowing that the maximum angle of rotation of the assembly in its current motion is 90° counterclockwise (Position 3), answer the following. D B -0.4 m A 0.4 m 3. Which of the following best approximates the value of the potential energy of the system at Position 2 with the datum at the level of pin B? NOTE: ANSWER IS NOT -2.943 NOTE: ANSWER IS NOT -2.15J and +2.15J is not in the options 4. Which of the following best approximates the total mechanical energy at Position 3? 5. Which of the following best approximates the angular velocity of the system at Position 2? NOTE: ANSWER IS NOT 7.09 rad/s

Two identical slender rods AB and BC (MAB = MBC = 1.5 kg) are welded together to form an L shaped assembly. The assembly is pressed against a spring at D and released from the position shown (Position 1). The assembly then passes through the position where rod AB forms an angle of 60° counterclockwise from the horizontal (Position 2). Knowing that the maximum angle of rotation of the assembly in its current motion is 90° counterclockwise (Position 3), answer the following. D B -0.4 m A 0.4 m 3. Which of the following best approximates the value of the potential energy of the system at Position 2 with the datum at the level of pin B? NOTE: ANSWER IS NOT -2.943 NOTE: ANSWER IS NOT -2.15J and +2.15J is not in the options 4. Which of the following best approximates the total mechanical energy at Position 3? 5. Which of the following best approximates the angular velocity of the system at Position 2? NOTE: ANSWER IS NOT 7.09 rad/s

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

PLEASE WRITE LEGIBLY, COMPLETE SOLUTIONS WITH DRAWING THANK YOU! A car weighing 9 kN travels at 80 km/hr. At the foot of an incline of 10%, the engine stops. Determine: a – acceleration. b – time for the car before it stops. c – distance traveled by the car before it stops.
*NOTE ON INSTRTUCTUONS AND HINTS
The displacement of a piston in cubic inch with a cylinder bore of 7.62-cm and the stroke is 3-in.
Find warrk done
Find the Ixx value for the plate as shown below, where b1=d2=18 mm, d1=85 mm,b2=65mm. (ENTER ONLY THE VALUES IN THE BOXES BY REFERING THE UNITS GIVEN IN THE BRACKET) b1 b2 d2 d1 O The X value (unit in mm) =.
Hi, Could you please help with this question, if you need to take more credits then please feel free. showing working out if possible too please, Thank you
*NOTE ON INSTRTUCTUONS AND HINTS
Show all work and steps please
Please only answer number 8
When do the actual dimensions occur?
I need the answer as soon as possible
A steel cylinder 5 inch in diameter is to be machined in a lathe. If the desired linear velocity of the cylinder's surface is to be 2.3 ft/sec. At how many revolutions per minute should it rotate? 122.67 rpm 105.14 rpm 112.28 rpm O 114.06 rpm