1. Solve for members AB, BE and DE (twice) using both Methods of Joints and Sections.

Q: I need answers to parts 4, 5, and 6, pertaining to the print provided.

A: For the weld between parts TP1 and TP2, 3 means weld symbols in accordance with ISO 2553.

Q: why are some weld joints grooved?

A: Welding is a material joining process in which two or more parts are coalesced at their contacting…

Q: A fillet weld can be used to join which of the following joint types: * O All of the Mentioned

A: Fillet welding is the process of welding to weld the 2 metals at an angle or perpendicularly.

Q: What is the relationship between the degrees of freedom and the types of joints?

A: Given: Relationship between the degree of freedom and the types of joints

Q: For Problems 7-12, design a welded joint to join the two members shown in the appropriate figure.…

A: Given: To find: Design the welded joint

Q: Refer to drawing 21A044, How many full threads will the fine tapped hole contain at minimum depth…

A: A standard thread form and series, along with allowances, tolerances, and designations, for screw…

Q: How to calculate the threaded hole axial shear strength of an aluminum 7075 1 inch thick plate. The…

A: Step 1: Given: Material Properties:Aluminum 7075 shear strength: 38000 psi (typical value)Thread…

Q: Draw the assembly views of the following G Clamp from a front view and top view. Provide a standard…

A: To Draw the assembly views of the following G Clamp from a front view and top view.

Q: Find the eccentricity of the welded connection by using 5 mm fillet weld. -120 mm - 200 mm 400 mm X-…

A:

Q: Sketch the groove welds specified and show all given weld dimensions

A: Sketch the groove welds The groove weld is a most common welding in which root opening is present.…

Q: How can we determine the displacement with truss?

A: Virtual work method: This method is a very important method which s used to find the slope as well…

Q: Please select all that applies. The possible failure modes for bolted joints are: shear in the bolts…

A: To select: The correct options. Concept used: Failure of the bolted joints: The bolted joints may…

Q: By what means kind of small area or stripe be selectively hardened and a large steel pa

A: induction hardening and flame hardening

Q: Step 1: Given: specific gravity, G=1.7 The objective is to determine: a. density of fluid in…

A: Specific gravity G = 1.7Find(1) Density ρ(2) specific weight ɣ

Q: I need answers to parts 10, 11, and 12, pertaining to the print provided.

A: (11)Cutting plane line consist of arrows at its ends and these arrows at the ends of the…

Q: High tensile strength materials are cut by a single point cutting too with the negative rake angle

A: Yes ,High tensile strength materials are cut by a single point cutting too with the negative rake…

Q: In most cases, pre-loading a bolted tensile joint increases the fatigue factor of safety. has no…

A:

Q: When can the moment-area method be used?

A: The moment area method is used to find the deflection and slope at a particular point in the beam.…

Q: diameter? 9. How deep is the counterbore? 1. Approximately how long is the tapped hole? . What does…

A: 10. Approximately how long is the tapped hole