1. Peripheral milling is performed on the top surface of a rectangular work part that is 400 mm long by 50 mm wide. The milling cutter is 70 mm in diameter and has five teeth. It overhangs the width of the part on both sides. Cutting speed 60 m/min, chip load 0.25 mm/tooth, and depth of cut 6.5 mm. Determine maximum material removal rate during the cut.

1. Peripheral milling is performed on the top surface of a rectangular work part that is 400 mm long by 50 mm wide. The milling cutter is 70 mm in diameter and has five teeth. It overhangs the width of the part on both sides. Cutting speed 60 m/min, chip load 0.25 mm/tooth, and depth of cut 6.5 mm. Determine maximum material removal rate during the cut.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

I need a solution within 15 minutes
A cylinder of 155 mm diameter is to be reduced to 150 mm diameter in one turning cut with a feed of 0.15 mm/rev and a cutting speed of 150 m/min on a NC lathe. What are the programmed feed rate and the material removal rate
In face milling, assume that the Diameter of the cutter is 200 mm, the width of the block is 60 mm, and the length of the block is 344 mm, if the depth of cut is 3 mm, = 0.6 mm/min, and N = 100 rpm. The cutter has 12 inserts, and the workpiece material is bronze. Calculate the estimated power required, the cutting force, and the torque.
Please answer it correctly. Thank you
Machining time required reduce a mild steel rod of diameter 60mm, initial length (L) 125mm to final length (L1) 120mm to 58 mm by turning a carbide insert. If the approach length and over run length are 5 mm and 1 mm respectively, take Cutting speed as 20 m/min and feed is =0.2 mm/rev, and the depth of cut is 0.5mm
How much machining time required to turn a mild steel rod from 65mm to 58 mm over a length of 100 mm by turning using a carbide insert. If the approach length and over run length is = 5 mm, Cutting speed is 20 m/min and feed is =0.2 mm/rev, and the depth of cut is 0.5mm D
A 450 mm long work piece is finished using a face milling cutter with a diameter of 75 mm. The overrun is 4 mm and the cutting depth of 3 mm. Calculate the total milling length.
Calculate amount of removed chips in (m³/min), If you have cutting width is 50mm, cutting depth is 10mm and .Feed speed is 4.15 mm/min 1.99 m³/min O 3.099 m³/min 2.075 m³/min O
I need the answer as soon as possible
In turning of stales steel alloy, 1100 mm length and 400 mm diameter, the Feed was 0.35 mm/rev, and depth of cut = 2.5 mm. The tool used in this cutting is cemented carbide tool where Taylor tool life parameters are n = 0.24 and C = 450 (tool life (min) and cutting speed (m/min). Compute the cutting speed that will allow the tool life to be 10% longer than the machining time for this part.