17) A50-mm-dia endmill cuts 6061 aluminum with 30% tool engagement at a depth of 6 mm. The tool rotates at 200 rpm and is feeding at 250 mm/min. There are 2 teeth set at a rake angle of 10°. a. Calculate the required power of cutting. b. Determine the spindle torque. c. Determine the cutting force on each tooth.

Q: In an orthogonal cutting operation an 8 mm deep groove is to be turned on a 50 mm diameter steel…

A:

Q: Through hole of 12 mm diameter is to be drilled in a steel plate of 20 mm thickness, drilled spindle…

A: Given: The diameter of hole is d=12 mm. The thickness of steel plate is t=20 mm. The drilled…

Q: In a multi point cutting tool the negative rake angle is used for high tensile strength materials.…

A: In multipoint cutting tools, the angle of the rake surface from the reference plane that is normal…

Q: The time required to saw a rectangular piece of stainless steel plate 3.5 meters long and 2.25…

A:

Q: A two-spindle drill cuts two holes at the same time, one 1/2 inch and one 3/4 inch. The workpiece is…

A:

Q: The time required to saw a rectangular piece of stainless steel plate 3.5 meters long and 2.25…

A:

Q: thickness is HW3.A block of steel has a length L-600mm and a width W-450mm. The Machined 10mm, once…

A:

Q: Calculate the ranges of typical machining times for face milling a 250-mm-long workpiece with a…

A: solution to first three sub-parts as per our company policy:

Q: or a turning operation, the cutting speed is 2.5 m/sec, and the depth of cut is 3 mm. A thrust force…

A: the cutting speed, v = 2.5 m/sthe depth of cut, d = 3 mm = 0.003 mThe thrust force, Ft = 300 Nthe…

Q: The positive rake angle in a single point cutting tool is used to cut non-ferrous metals and low…

A: Positive rake angle is used to reduce shear strain, low power consumption, low cutting force, Less…

Die Stock

Die stock is expressed as the type of component which is utilized for fitting purposes while creating or shaping uniform threads on tubes, pipes, or screws. The die stock (die handle) has three screws around the adjustable part of a particular machine that helps to locate the die. Also, die stock can endure on a variety of hex and split adjustable dies of several dimensions. One of the primary reasons for using die stock in industries is because die stock can be operated by hands. Commonly, it is made up of high carbon steel.