1. Members KJ, KD, CD, and IH 2m L 4 KN B 2m 5 kN K C 2m 6 KN D 3m E 1 3m F H 3m 4m

Q: For the truss system shown in Figure 3: a. Sketch a free body diapram showing all forces acting, b.…

A: a. Following is the free body diagram of the given truss:

Q: 2. The rigid bar of negligible weight is pinned at O and attached to two vertical rods. Assuming…

A:

Q: Determine the the force in member GJ of the truss and tate if this member is in tension or…

A: Given that : F = 1050 lb Intro : 1- It is asked to determine the forces in member GJ and GC of the…

Q: For the truss shown below, F= 12 kN and L= 3 m. a) Determine the force in member BE. A and E are…

A:

Q: Determine the forces in all bars of the truss shown in the given figure. Indicate tension or…

A: Given TrussLoading 40, 30, 20 and 18 kNTo find out Member forces

Q: A simply supported planar truss is subjected to point loads at joint B and D as shown in Figure 2.…

A: Find the reaction of the truss calculate θ=tan-113.2710=52.99° and α=tan-113.275=69.35°consider ∑…

Q: The rigid bar BDE is supported by two links AB and CD. Link AB is made of aluminum (E = 70 GPa) and…

A: For the given rigid bar,

Q: The bars of the pinned-connected truss shown in Figure below are each 30 mm by 60 mm in…

A:

Q: 8. A rigid bar AB is supported by three rods. A load P = 350 kN is applied to the bar. The modulus…

A: To Find :- Deformation in the rods in mm

Q: Q2: The pin-connected structure shown in figure below consists of a rigid beam ABCD and two…

A: My dear  Given Area of bars Youngs modulus Point load at B We will use compatibility equations and…

Q: Using method of joints, analyze the following figure if: 0=30°, Q=60°, and d=10 ft 625 lb D 750,lb…

A:

Q: The truss is made from three pin-connected members having the cross-sectional areas shown in the…

A: Given

Q: All members of the aluminum truss have the same cross-sectional area. Member AD and CD are made of…

A: Data Given: ∆T = 80° - 20° = 60°Cαsteel = 11.7 × 10-6/°Cαaluminium = 23.1 × 10-6/°CEsteel = 200…