1. How much resistance is required to limit the current to 24 mA if the potential drop across the resistor is 48 V? (30 pts) Ans: 2. The current through a 4 k resistor is 7.2 mA. What is the power delivered to the resistor? (30 pts) Ans: 3. What is the maximum permissible current in a 10 £2, 4 W resistor? What is the maximum voltage that can be applied across the resistor? (40 pts)

Q: If the diode is disconnected, then 4 5 6 The discharging time (7₂) (in ms) The duty cycle (ratio)…

A: Here our task is to find the output frequency of the 555 timer oscillator circuit once the diode is…

Q: PROBLEM NUMBER 1 For the configuration below, an ac signal of 12mV applied, resulting to emitter…

A: Answer the above question are as follows

Q: . an air handling unit mixes 0.8m3/s of fresh air at 32 °C DBT and 23 °C with 4m3/s of re-circulated…

A:

Q: Ex) A standard two-junction thermocouple configuration is being used to measure the temperature in a…

A: According to the information given:- We have to follow the instruction to determine the output…

Q: H.W./A 600V voltmeter is specified to be accurate within ± 2% at full scale. Calculate the limiting…

A: here in the question given 600V voltmeter which is specified to be accurate within 2% at full scale.

Q: In the given i-v characteristic below, which load line represent the given circuit? I-V curve for a…

A: Load line: The load line is generally a straight line. The load line is drawn on the characteristic…

Q: Q1) Write a sketch in IDE for an ultrasonic reversing sensor mounted on a mobile robot driven by two…

A: the answer is given below:-

Q: 9- A certain logic gate has a VOH(min) these gates compatible for HIGH-state operation? Why? = 2.2…

A: According to the Bartelby guideline we are suppose to answer only one question at a time. Kindly…

Q: 1- An antenna has impedance of 36-j24 with internal loss of 4 ohm is used to receive a radio signal.…

A: Let see the solution below.-

Q: method of heat transfer principle is used to monitor changes in temperature in contact type…

A: Contact type temperature sensors required physical contact with the object and use conduction to…

Q: :- For a single phase half wave controlled rectifier with (RL) load if the input supply voltage is…

A: Solution:   Given, For a single phase half wave controlled rectifier with (RL) load if the input…

Q: Pressure sensor converts pressure into

A: Dear Student, Pressure Sensor is a device equipped with pressure sensitive element to determine…

Q: 1. By using the tincker-cad Set up the equipment as given below make sure the resistance value is…

A: According to the information given:- I am using TinkerCad to setup this equipment with resister…

Q: (10 pts each) Simplify the circuit using Laws of Boolean Algebra, Rules of Boolean Algebra and…

A:

Q: For a system having damping factor, 8 =0.7 and frequency of natural oscillations, wn =14.5 rad/sec.…

A: I have given an answer in step 2.

Q: + 5 V 4 ww ww 3.

A: complete step process answer given in step 2

Q: Q1. Timing analysis (Graded for completion) CLK CLK CLK Given the circuit, each two-input XOR gate…

A: Actually, flip-flop is a circuit. given information Each two-input XOR gate has : a propagation…

Q: (a) Half duplex is one of the types of communication system. With aid of a diagram, give one…

A: Half Duplex: Only one direction of transmission is possible with half-duplex devices. Data can move…

Q: 1. What is the wavelength of a radio wave with a given frequency of 450 kHz?

A: Answer is given below-

Q: a- Desilte

A: We need to solve these 6 Questions.

Q: R3 20 V IR a R1 200 Ω E2 + : 200 Ω E3 100 N VR RL 10 V Is R2 b 150 mA

A: See the full solution  below-

Q: Where should the thermometer bulb be located for internal monitoring ina. a distillation apparatus…

A: (a) When Hickman apparatus is used in a distillation apparatus, the thermometer bulb must be located…

Q: 01: A/ For RC electrical circuit shown in Figure R v,(1) 1- Derive the differential equation RC…

A:

Q: (d) Consider a synchronous circuit with a critical path consisting of 10 logic gates, and for which…

A: Given, Consider a synchronous circuit with a critical path consisting of 10 logic gates, and for…

Q: According to De-Morgan's Theorem, A+ (A +B) +BC is equal to A .(A+B). ( BC ) A +(A+B)+(B + C ) O…

A: De Morgan’s theorem states that the complement of the and (.) of all terms is equal to the or(+) of…

Q: (b) For the following Fixed Biased Junction Field Effect Transistor, determine 9 16 V (i) VGSQ (ii)…

A: Question :

Q: A Full-wave rectifier is used to supply 50V D.C to a resistive load of 800 2. The diode ha…

A: It is defined as a device that converts an oscillating two-directional alternating current (AC) into…

Q: 4. A ring oscillator is built from N inverters connected in a loop. Where each inverter has a delay…

A:

Q: 1. Describe the speed control of three phase induction motor in this Fig 2. What are the salient…

A: 1.Speed control of three phase induction motor:…

Q: Q3: A ball bearing of type (single-row deep groove) is exposed to a half minute work cycle that…

A: Single row deep groove ball bearings are the most widely used roller bearing type in the world due…

Q: 3. Discussion 1. What is the effect of the diode voltage drop on the output of the clipping circuit…

A: 1.In this circuit an output waveform is obtained when the voltage across diode exceeds the barrier…

Q: sho ig./ ncrease the input voltage gradually in several steps from 0 to 15V, and record Vz and Iz…

A:

Q: Please answer in typing format

A: Step 1: Step 2:

Q: In a given system, if the damping factor is observed to be equal to 1.6 then the system is…

A: Damping ratio describes how oscillations in a system decay after a disturbance. Damping ratio is a…

Q: Please solve it correctly and fully

A: Analyze the circuit to develop the boolean function for the given question and then start analyzing…

Q: e the given circuit and draw its state table and sta

A: Analyze the circuit to develop the boolean function for the given question and then start analyzing…

Q: (a)the positive supply voltage (b) the negative supply voltage (c) Zero (d) the CMRR 3. Bias current…

A: given - questions regarding instrumentation amplifiers?

Q: Find the activity factor at the output of each gate if P at A, B and C are all equal to ½, and the…

A: It is given that inputs (A, B, C) we know that the probability of the output of NAND gate being a…

Q: 1) Analyze the circuit provided in Figure 1 to obtain a value for the Thévenin equivalent resistance…

A: The, answer has given below;

Q: 1.Design a feedback bias a circuit using a Vee supply of +18v, and an npn silicon transistor with…

A: hand written solution down

Q: Q2/A 600V voltmeter is specified to be accurate within 2% at full scale. Calculate the limiting…

A: 600V voltmeter