1. An eccentrically loaded foundation is shown. Use a factor of safety of 3 and determine the maximum allowable load the foundation can carry. Use Meyerhof's effective area method. (Eccentricity in one direction only) e = 0.15 m y = 17 kN/m 10 m '= 36° 1.5 m x 1.5 m Centerline

1. An eccentrically loaded foundation is shown. Use a factor of safety of 3 and determine the maximum allowable load the foundation can carry. Use Meyerhof's effective area method. (Eccentricity in one direction only) e = 0.15 m y = 17 kN/m 10 m '= 36° 1.5 m x 1.5 m Centerline

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A 2.0 m wide square foundation is placed at 0.5 m depth in a saturated clay where c = 40 kN/m² and y…

A: Width of the foundation (b) = 2 mDepth of the foundation (h) = 0.5 m Cu = 40 kN/m2Unit weight = 19.0…

Q: 12.4

Q: Two continuous foundations are constructed alongside each other in a granular soil. Given for the…

A: The centre to centre spacing for the foundation is at x = 2 m.

Q: Use Meyerhof's equation

A: i hope its helpfull.thank you.

Q: A 1.5 m wide continuous foundation carries a wall load of 375 kN/m on a clayey soil where y = 18…

A: Width of footing, Depth of footing, Wall load, Bulk unit weight, Cohesion, Angle of friction, To…

Q: 4.6 For a square foundation that is B X B in plan, D, = 2 m; vertical gross allowable load, Qall =…

Q: According to the given information, it is desirable to determine the net allowable tolerable load by…

Q: Ib y= 110 ft3 P= 30° c=0 5 ftf

Q: A shallow foundation measuring 1.75 mx 1.75 m is to be constructed over a layer of sand. Given: D,=1…

A: footing size=1.75×1.75 m Df = 1m N¯60= 10 q=120 kN/m2 To calculate = elastic settlement of the…

Q: Using the general bearing capacity equation, what is the factor of safety for a foundation system…

Q: The shallow foundation is shown in Figure 4.24 measures 1.5 m X 2.25 m and is subjected to a centric…

A: Given :

Q: A square foundation in a sand deposit measures 4 ft x 4 ft in plan. Given: Df = 5 ft, soil friction…

A: Given, Size of foundation = 4ft×4ftDepth of foundation, Df = 5 ftAngle of friction, ϕ = 35oUnit…

Q: Problem 3 An eccentrically loaded foundation is shown in Figure 3. Use factor of safety (FOS) of…

Q: A square foundation with a depth of 1.5 m will carry a load of 3000 kN. Soil has a property index of…

Q: nder the one-way eccentric load, if the base react cionship between the eccentric distance e and t…

Q: A square foundation is 3mx3m in plan. The soil supporting the foundation has a friction angle of Phi…

A: A Square foundation of 3mx3m.Friction angle of Phi = 21 degreesC' = 22KN/m2Depth of foundation (Df)…

Q: 4) A rectangular foundation 1.5m x 2.0m is located at a depth of 2 meters below the ground surface…

A: A rectangular foundation 1.5m x 2.0m located at a depth of 2 meters below the groundbelow the…

Q: A square foundation is 1.5 m X 1.5 m in plan. Given the soil properties supporting the foundation…

Q: 5. The shallow foundation measures 4 ft * 6 ft and is subjected to a centric load and a moment. If…

Q: A square foundation must withstand an allowable load of 1805 kN reliability of 3. With the given…

Q: Calculate the settlement for the center of a flexible foundation due to volume distortions in the…

A: Given: The size of the footing is 6 ft by 6 ft. The load on the footing is 120 kips. The shear…

Q: Given: A square foundation (4.5m x 4.5m) is founded at 2.4m in a soil with the following properties:…

Q: A square foundation has to carry gross allowable load of 1805 kN (FS=3). Given: D, = 1.5 m, y=15.9…

Q: Calculate the weight of a Wire Mesh Reinforcement needed for a 10'x10' slab. The specifications are…

A: Requirement of wire mesh reinforcement in slab Mesh reinforcement is required in a composite slab…

Q: A (5m x 5m) square foundation is constructed at 2.5m in a soil with the following y = 18.34 kN/m³ c'…

A: Based on this theory, shallow foundations have depths equal to or less than their widths. According…

Q: A shallow foundation measuring 1.75 m x 1.75 m is to be constructed over a layer of sand to support…

A: B = 1.75m P = 400 kN Df = 1 m N60 = 12

Q: The longitudinal foundation is located on the ground as shown in Figure 1. The foundation is located…

A: we know that Terzaghi eq for longitudinal or stip foundationbearing capacity…

Question

1. An eccentrically loaded foundation is shown. Use a factor of safety of 3 and determine
the maximum allowable load the foundation can carry. Use Meyerhof's effective area
method.
(Eccentricity in
one direction only)
e = 0.15 m
| Qall
Y = 17 kN/m
c = 0
'= 36°
%3D
10 m
1.5 m X 1.5 m
Centerline

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 10 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 2.0 m wide strip foundation is placed in sand at 1.0 m depth. The properties of the sand are: = 19.5 kn/m3, c’ = 0 and ’ = 34. Determine the maximum wall load that the foundation can carry, with a factor of safety of 3.0, using Meyerhof’s modified bearing capacity equation with appropriate factors
An eccentrically loaded continuous foundation is shown in Figure P6.18. Determine the ultimate load Qu per unit length that the foundation can carry. Use the reduction factor method [Eq. (6.67)]. 4 ft 2 ft Figure P6.18 Qu 2 ft → -5 ft Y = 105 lb/ft³ Groundwater table Ysat 118 lb/ft³ c' = 0 $' = 35° =
Use Terzaghi's equation and Terzaghi's Table
A square foundation is shown in Figure P6.19. Use FS = 6,and determine the size of the foundation. Use Prakash and Saran's method [Eq. (6.59)].
Two continuous shallow foundations are constructed alongside each other in a granular soil. Given, for the foundation: B =1.2 m, Df=1 m, and center-to-center spacing =2 m. The soil friction angle, ∅=35°. Estimate the net allowable bearing capacity of the foundations. Use a factor of safety of FS=4 and a unit weight of soil γ=16.8 kN/m3.
According to the form and assumption of reliability coefficient 4, it is desirable to determine the allowable load tolerable by the foundation. (Eccentricity in one direction only) 0.1 m y= 17 kN/m e = 0 d'= 32° 0.8 m 1.5 m X 1.5 m Centerline