1. A swimming pool 15m long,10m wide 3m deep at one end,and 1.6 m on the other end is fitted with a drain 175mm in diameter at the lower end of the pool compute the time required to drain the full content of the pool assuming C= 0.85

1. A swimming pool 15m long,10m wide 3m deep at one end,and 1.6 m on the other end is fitted with a drain 175mm in diameter at the lower end of the pool compute the time required to drain the full content of the pool assuming C= 0.85

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Situation 1: Give the discharge/flow rate in (m/s) of the system with a constant velocity of 2.5m's…

Q: Group work Example Two reservoirs with a difference in water levels of 180 m and are connected by a…

A: Head = H = 180m Length = L = 64Km or 64000m Diameter of pipe = D = .6m Friction factor = f = .015

Q: Water Supply from an Unconfined Aquifer Question 1. Water will be supplied with pump from a well in…

A: Given Hydraulic conductivity k=0.003 m/sand maximum velocity of flowVmax=k30=0.00330=0.01…

Q: Water flows under a sluice gate in a horizontal rectangular channel of 2 m wide. If the depths of…

A: In this problem, we are asked to calculate the discharge of water flowing under a sluice gate in a…

Q: A reservoir discharges through a sluice 0.915 m wide by 1.22 m deep. The top of the opening is 0.61…

Q: A confined aquifer underlies an unconfined aquifer as shown in the illustration below. Given the…

Q: Two pipes are connected in parallel between two reservoirs: L1= 2000 m, D1= 160 cm, C1=120; L2= 1400…

A: Given: Two pipes connected in parallel,L1 = 2000 m L2 = 1400 mD1 = 160 cm D2 = 800 mmC1 = 120…

Q: The water surface in reservoir X is 6 m higher than that in reservoir Y. A 150 mm diameter pipe 270…

A: Bernoulli's equation generally defines the total mechanical energy of the flowing fluid comprising…

Q: Two tanks A and B. of constant cross-sectiona rea of 10 m² and 2.5 m², respectively, are onnected by…

Q: A circular sewer flowing full to carry a sewage discharge of 0.864 m3/s at a slope of 10 in 20000.…

Q: A rectangular orifice of width 1.5 m and depth 1 m is used in a tank. The water level in the tank is…

A: Given: Width, b = 1.5 m Depth, d = 1 m Water level above top edge of orifice, H1 = 3 m Coefficient…

Q: The water in an 8-m-diameter, 3 meter high above the ground swimming pool is to be emptied by…

A: For the given swimming pool,

Q: A 1 m 2.5 m 8 m

Q: (6a) A siphon is made of a pipe whose inside diameter is 25.4 mm and is used to maintain a constant…

A: Data given Siphon pipe, diameter = 25.4 mm = 0.0254 m Depth of tank = 6.0975 m

Q: SITUATION #2c: Three pipes 1, 2, and 3 from three reservoirs A, B, and C, respectively, meet at a…

Q: 7. A stream having a discharge of 280L/sec per meter width of channel has a depth after the jump of…

A: Let V1 be the velocity of water before jump. y1 be the depth before jump. - Find Depth before jump…

Q: Calculate the flow discharge in a 7-m-wide rectangular horizontal channel where the flow depth and…

A: Given, width of channel, W = 7m Depth, d = 0.7m Velocity, v= 7m/s To calculate: Discharge (Q)

Q: Pipe B 266 m, 160-mm diameter Pipe A 300 m, 200-mm diameter Pipe D S10 m, 250-mm diameter Pipe C 190…

Q: A 170-m long pipeline, composed of two pipes connected in series, discharges freely at a point 40 m…

A: The total loss in the pipeline for the given question is given by: hL=hentrance+hsudden…

Q: Question- A pipe of 324 mm diameter, having friction factor as 0.04, connects two reservoirs with 15…

Q: through the meter shown exis ns: 0.0153 m/s) P=900kPa P2 = 550 kPa (1) 35 mm • (2) 25 mm

A: According to given Data

Q: Example 8: A flocculation basin is designed to treat water of 1 m³/s flow rate. The length of the…

Q: Water is moving between two reservoirs at a flow rate of 0.08 m³/s via the pipes shown in the…

A: Given: D1=10cm, D2=20cm, Ks=0.08, Flow rate=0.08m3/s , L1=50m

Q: Three reservoir are connected as shown in figure 1. What is the discharge in each line? All pipes…

A: The given figure is shown below:

Q: Q.07 A reservoir discharges through a sluice 0.915 m wide by 1.22 m deep. The top of the opening is…

Q: A tank 6 meters long and 3 meters deep is 3 meters wide at the top and 6 meters wide at the bottom.…

Q: coefficient of discharge

A: Given: Diameter of the orifice = 150 mm Co-efficient of discharge = 0.62 To find: Time taken for the…

Q: A 900 mm diameter pipe 1,800 m long carries 1.2 cu.m./sec from reservoir A, whose water surface is…

Q: A flow of water of 0.1 m³/sec flowing through rectangular tube of width 550 mm and having adjustable…

A: Given: Discharge, Q = 0.1 m3/s Width, W = 550 mm Depth, H = 250 mm C = 55

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Within few minutes
Water enters a pipe of length 10ft and diameter 2 inch with a mass flow rate of 150 kg/min. The density of water at a pressure of 2 bar is 961.5 kg/m³. Determine the work done at the entrance of pipe.
The reservoir's water flow traverses a 15-meter-long spillway, lowering the water's height from 83 meters to 81.5 meters, with the crest elevation at 80 meters, in 30 minutes. Apply C = 1.84. A) What is the reservoir's area?B) How long does it take to extract water from an elevation of 83 m/80.2 m? C) After 20 minutes, what is the water's ultimate elevation?
Thank you professor !!
Within 5 minutes
01(a) There are two reservoirs, A and B, with the water surface elevation in A 10 m higher than that in B. These are connected through two pipes in series with pipe 1 starting from A and pipe 2 ending in B. Lengths of both the pipes are 100 m, diameter of pipe 1 is 30 cm and diameter of pipe 2 is 25 cm. At the junction of these pipes, water is being withdrawn at the L v² D 2g rate of 0.02 m³/s. Friction loss in the pipes is given by h = f and the Darcy friction, f, entrance and at the junction, for both pipes is 0.02. Neglecting the head losses at the estimate the total water withdrawal from reservoir A.
A vertical circular tank that is 1.5 m high, has sloping sides. The tank is 50 m and 30 m in the top and bottom diameters respectively. Discharge takes place through a triangular orifice situated at the bottom of the tank. The orifice has a base of 0.8 m long, 0.5 m below its vertex. If the tank is originally full of water, what time is required to empty the tank? Take discharge coefficient as 0.63 Show all formulas and values that are substituted PLEASE
A vertical cylinder having a circular base of radius 'r' and a height of 12 m is filled with water at the rate of 1 m3/min. If the depth of water in the cylinder at the vertical position is 3 m, what would be the resulting depth when the cylinder is in the horizontal position? OA 0.30r O B. 0.40r OC.0.50r O D.0.60r
A water pipe having a 2.33 cm inside diameter carries water into the basement of a house at a speed of 0.887 m/s and a pressure of 241 kPa. If the pipe tapers to 1.27 cm and rises to the second floor 7.37 m above the input point, what are the (a) speed and (b) water pressure at the second floor? (a) Number i Units (b) Number i Units