1. A heat engine is found to have an efficiency of 0.3. If it does 180 J of work per cycle, what are the corresponding quantities of heat absorbed and discharged? Enter absolute values. Heat absorbed: Heat discharged:

1. A heat engine is found to have an efficiency of 0.3. If it does 180 J of work per cycle, what are the corresponding quantities of heat absorbed and discharged? Enter absolute values. Heat absorbed: Heat discharged:

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: 170 g of water at 105°C is converted to steam. What is the entropy change of the water that is now…

A: latent heat of boiling water = 2256 KJ/kg = 2256 J/g mass = 170 g Heat required to change the state…

Q: engine absorbed 571,100 J of energy from a reservoir that had a temperature of 848 K and expelled…

A: Given Temperature of reservoir T1 = 848 K Temperature of sink T2 = 342 K Heat taken from source Q1…

Q: A refrigerator requires 10 J of work and exhausts 70 J of heat per cycle. What is the…

A: Given data :- Work done W = 10 J Heat exhausted Q = 70 J

Q: An engine with an output of 249.0 W has an efficiency of 25.0 %. It works at 10.00 cycles/s. How…

A: It is given that the output power is 249.0W. It is the work done per second. This implies, 249.0 J…

Q: 0.2kg cup of tea at Ti=368.15K is left to cool down in a room at 293.15K.Above cup of tea iscooled…

A: Thermodynamics.

Q: The hot and cold reservoirs of a Carnot engine are 323°C and 66.7°C respectively. The temperature of…

Q: A heat pump has a coefficient of performance of 3.1. Hint If it requires 290 J of work per…

Q: It is found that an engine discharges 50 J while absorbing 85 J each cycle of operation. Hint a.…

A: Detailed solution of given question is given in below steps.

Q: 1. An engine with an efficiency of 0.2 absorbs 510 J of heat per cycle. (a) How much work does it…

A: Efficiency of an engine is defined as: Efficiency η=work performedheat absorbed…

Q: What happens to the efficiency of the heat engine when the amount of heat it absorbs from the hot…

A: Given data: Heat absorbed from hot reservoir = Heat released to cold reservoir Qh = Qc Required:…

Q: An engine absorbed 865,500 3 of energy from a reservoir that had a temperature of 539 K and expelled…

Q: Half of a 1.5-kg block of ice melts at 0.00°C. What is the change in entropy of the ice? Note that…

A: given that,mass, m=1.5 kgheat of fusion L=333kJkgT=0°C=273 K

Q: An ice-making machine operates in a Carnot cycle. It takes heat from water at 270 K and rejects heat…

A: Given: Heat extracted from cold reservoir per cycle is given; 27. Thermal efficiency of this…

Q: 100 g of water at 0 0C is heated to 100 0C. Compute its change in entropy.

Q: A heat engine draws in 537 J of heat and expels 121 J of heat. a) Find the work produced by the heat…

A: Given Qi=537J Qe=121J

Q: 2.A refrigerator has a coefficient of performance equal to 6.00. The refrigerator takes in 110 J of…

A: For a refrigerator Work done is given by W= Q1 - Q2 Q1 is the Heat expelled to the hot reservoir.…

Q: During one cycle, a refrigerator removes 360 J from a cold reservoir and discharges 530 J into its…

Q: A Carnot engine extracts 200J of heat from a 600K hot reservoir every cycle. The cold reservoir…

Q: 1. A coal-fired power plant produces 9.00 × 1013 J of electrical energy in one day, and operates…

Q: A gasoline truck engine takes in 10,000 J of heat and delivers 2,000 J of mechanical work per cycle.…

A: From the figure, the engine is a Carnot engine. Let QH denotes the heat received from the higher…

Q: A Carnot engine draws heat energy from a hot temperature reservoir at 250oC and deposits heat energy…

Q: A heat engine with an efficiency of 30% takes in 800 J of heat from the high-temperature reservoir…

A: Given: The efficiency of the heat engine is 30%. The heat input to the engine is 800 J.

Q: A heat engine with an efficiency of 0.21 absorbs 400 J of heat per cycle. Hint a. How much work does…

Q: A heat engine does 7300 J of work per cycle while absorbing 12 to 0 J of heat energy from the hot…

Q: Answer below questions for a heat pump that puts in 80 J of heat into the hot reservoir per cycle…

A: Given data, Heat given to the hot reservoir (QH)=80 J Coefficient of performance (n)=4

Q: 2. In lecture, it was stated that the ideal efficiency of the Otto cycle is € = 1 -(V2/V) 1 where Vi…

A: Here is the Answer and Explanation

Q: The efficiency of a Carnot engine is 46%. What will be the temperature of the cold reservoir if the…

Q: A heat pump has a coefficient of performance of 2.2 in heating mode. If it requires 140 J of work…

Q: Find the net work output per cycle for the thermodynamic cycle in the figure. P (atm) D 5 10 V…

Q: Part 1: Five thousand kilocalories (5000 kcal) of heat flows from a high temperature reservoir at…

A: Entropy change is related to the amount of heat transferred at a temperature T as, ∆S=∆QT∆Q is the…

Q: A heat engine operating between -10 degrees Celsius and 40 degrees Celsius achieves 50% of the ideal…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: An engine has a hot-reservoir temperature of 900 K and a cold-reservoir temperature of 600 K. The…

A: We are given a heat engine. This heat engine is not Carnot engine. We are given the efficiency of…

Q: A heat engine with an efficiency of 0.45 absorbs 540 J of heat per cycle. a. How much work does it…

Q: A heat engine is found to have an efficiency of 0.33. If it does 190 J of work per cycle, how much…

Q: A gasoline engine has a compression ratio of 6.00 and uses a gas for which ? = 1.40. What is the…

Q: 2.0Kg of water at 0 degree celcius heated to 100 degree celcius. Compute its change in entropy. Mc…

A: Check out the form of chemical

Q: in a single cycle, a heat engine extracts 8.00 kcal of heat from a hot reservoir and exhausts 5.00…

A: Given that, the amount of heat extracted from the hot reservoir is Qin=8kCal the amount of heat…

Q: 1. What is the efficiency of a steam engine if it absorbed an energy of 2.5 x 10*J from the boiler…

A: Given: heat absorbed Q1=2.5*108 Jheat rejected Q2 =1.5*108 J

Q: Question B2i. Give an equation for the infinitesimal change in entropy, ??, of a system in terms of…

A: The objective of the first part of the question is to provide the equation for the infinitesimal…

Q: 1. A certain gasoline engine has an efficiency of 31%. What would the hot reservoir temperature be…

Q: 18. A perfect engine would have On the other hand, a perfect refrigerator would need which would…

A: The fill in the blanks. A perfect engine would have ......................., which would lead to an…

Q: Identify the processes in the cycle. Þ 1. Path AB = The temperature in (1) is 350 K, the work done…

Q: A Carnot engine takes in heat from a reservoir at 460°C and releases heat to a lower-temperature…

A: Given, Hot reservoir temperature, Th=4600 C=733.15 K, and cold reservoir temperature, Tc=1400…

Q: 1. An engine with an efficiency of 0.2 absorbs 485J of heat per cycle. (a) How much work does it…

Question

1. A heat engine is found to have an efficiency of 0.3. If it does 180 J of work per cycle, what are the corresponding quantities of heat absorbed and discharged?

**Enter absolute values.**

- Heat absorbed: \_\_\_\_ J
- Heat discharged: \_\_\_\_ J

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A certain refrigerator requires 31.0J of work to remove 150J of heat from its interior. 1. What is the coefficient of performance? 2. How much heat is rejected to the surroundings at 21C? 3. If the refrigerator cycle is reversable, what is the temperature inside the refrigerator?
A heat engine provides a net power output of 14 kW and has an efficiency of 23 %. The engine rejects 1200 J of energy per cycle to a low temperature reservoir. a)Determine the amount of heat delivered to the engine from the high temperature reservoir per second. Your answer should be in units of Watts. b)Determine the required number of cycles per minute executed.
The temperature of the sink of a Carnot engine is 27. The efficiency of the engine is 25%.What is the temperature of the source?
Calculate the efficiency of a heat engine operating between two reservoirs at temperatures T₁ = 400 K and T₂ = 300 K. Select one: O a. η = 0.25 - Ο b. η = 3.0 O c. n = 4.0 O d. n = 0.33333333333333
An engine is found to have 0.44 efficiency. If it does 234 J of work per cycle, what is the heat absorbed? (The answer should be in Joule, but do not include the units in your answer). 531.82
A refrigerator has a coefficient of performance of 2.9. Hint If it requires 180 J of work per cycle, how much heat per cycle does the refrigerator remove from the cold reservoir? QL=QL= JJ How much heat per cycle is expelled into the hot reservoir? QH=QH= J
If a heat engine works in a Carnot cycle, what happens to its efficiency when the difference in temperature of the hot and cold reservoirs increases? Its efficiency: A. increases. B. decreases. C. becomes zero. D. remains the same.
An engine that absorbs 480 J of heat per cycle has an efficiency of 00.34. How much work W does the engine do in a cycle?
8. A heat engine with an efficiency of 40% takesin 600 J of heat from the high-temperaturereservoir in each cycle.a. How much work does the engine do in eachcycle?b. How much heat is released to the low temperature reservoir?
9) A heat pump is used to move heat from 10°C air outside, to a 22 °C air inside. The practical coefficient of performance of this pump is 4.1, and it uses 12000 J of electric energy. a) Find the energy this system adds to the house. b) Find the theoretical (maximum) coefficient of performance for this system. 5
Suppose a heat engine design makes a square on a PV diagram, using a monatomic gas. The high pressure is 3P and low pressure is P. The high volume is 3V and low volume is V. What is the efficiency of the heat engine?
A heat engine operates between a reservoir at 28°C and one at 350°C. What is the maximum efficiency possible for this engine? Need Help? Read It