1. A 150 X 90 X 12 mm angular section is welded to a gusset plate shown. Area of angular section is 2376 sq.mm. Fu = 550 MPa Allowable shear Fv=0.30FU Fy = 250 MPa Allowable tensile stress Ft = 0.60FY a. Determine the force P b. Determine the total length of weld using 12mm fillet weld c. Determine the value of a d. Determine the value of b

Q: A 12.5 mm x150 mm plate is connected to a gusset plate having a thickness of 9.5 mm.Diameter of…

A: A 12.5 mm x150 mm plate is connected to a gusset plate having a thickness of 9.5 mm.Diameter of bolt…

Q: For the given riveted connection shown, having the allowable stresses: Fy = 248 MPa Fy = 150 MPa…

A:

Q: Use hand written solution. Nscp 2015 steel design ty

A: To solve the problem of determining the load capacity of the column made of two channels C250×30…

Q: afe strength of a 5/16 in. fillet weld if it's actual length is 3 1/2 in. and the allowable unit…

A:

Q: Q-A 16 mm thick gusset plate is connected to the 12mm thick flange plate of an I-section using…

A:

Q: The following image shows a front and side view of the column connection. The bolts have a diameter…

A:

Q: Prob. 2.9-8. The steel eyebar in Fig. P2.9-8 has cross-sec- tional dimensions 25 mm x 100 mm. To…

A:

Q: The two wooden boards are connected by a 0.9 in. diameter bolt. Washers are installed under the head…

A:

Q: The steel shafts are connected together using a fillet weld as shown in the figure below. (Figure 1)…

A: T = 63 N. m

Q: A double U-shaped butt weld is to connect two plates 200 mm (d) × 20 mm (b), as shown in the given…

A: Given: A double U-shaped butt weld is connecting two plates of dimension, b=20 mmd=200 mm Moment =…

Q: Give the formula for the tensile and shear strength of the weld joint. Explain the various terms in…

A: Need to definethe formula for the tensile and shear strength of the weld joint

Q: For the given riveted connection shown, having the allowable stresses: Fy= 248 MPa, F, = 150 MPa…

A: Given data -b = 300 mmd = 20 mmFy = 248 MPaFv =150 MPaFind out -(1)Compute the diameter of rivets…

Q: The two wooden boards are connected by a 0.7 in. diameter bolt. Washers are installed under the head…

A: Given data The diameter of the bolt  = 0.7 in  The outer diameter of washer (D) = 2.4 in  The inner…

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.