1- Draw V-curves for synchronous motor at no load, half load, and full load? 2- List the advantages of damper bars in synchronous machines? 3- Draw phasor diagram for alternator at unity power factor, and derive EMF equation from it?

1- Draw V-curves for synchronous motor at no load, half load, and full load? 2- List the advantages of damper bars in synchronous machines? 3- Draw phasor diagram for alternator at unity power factor, and derive EMF equation from it?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

T-a. The direction of rotation of a single-phase split-phase motor can be change by........ a) reversing the connection of the start winding b) reversing the connection of the run winding c) reversing the connection of the start and run winding at the same time d) "a" or "b", not "c" T-b. Single-phase split-phase motors using an electrolytic capacitor in the start winding circuit should not be cycled more than about__________ time per hour. a) 8 b) 12 c) 24 d) none of the above T-c. When replacing the capacitor in a capacitor-start induction-run motor, one must be sure to replace the bad capacitor with__________ . a) a smaller one b) one of the same size c) a larger one d) none of the above
Draw a complete phasor diagram of a single-phase synchronous generator at a general unity power factor. Draw also the equivalent circuit of the generator. Phase resistance must be included in the phasor diagram.
and t A common base of 100 MVA and 25 KV is selected. What is the current base (Ig) Select one: O a. 4 KA O b. None of these O c. 6.25 kA O d. 2.309 KA A 100-MVA, 60-kV, three-phase synchronous generator has a synchronous reactance of armature resistance. The generator is operating with an excitation per phase E= 47.116 power before losing synchronism (stability limit). and the armature c Thus, the maximum generated power is Pmax =
D2. When a generator's full-load output voltage is the same as its no-load output voltage it is said to be a) under-compounded b) flat-compounded c) over-compounded d) none of the above D3. The output of an overcompounded DC generator can be lowered by use of a a) rheostat connected in series with the series field b) rheostat connected in parallel with the series field c) rheostat connected in parallel with the shunt field d) none of the above D4. When might it be desirable to use an overcompounded generator? a) never b) always c) to compensate for line loss d) when you need a higher no-load voltage than your full-load voltage
Can you please answer Problem 49 to 51.
In a certain sub-station, there are 5 d.c. shunt generators in parallel, ench having an armature resistance of 0.1 0, running at the same speed and excited to give equal inducnd emfs Each generator supplies an equal share of a total load of 250 kW at a terminal voltage of 500 V into a load of fixed resistance. If the field current of one generator is raised by 4%, the others remaining unchanged, calculate the power output of each machine and their terminal voltages under these conditions Assume that the speeds remain constant and flux is proportional to field current
Full solutions for the question with explanation
A 3-phase, 60 Hz, 6 pole alternator has an air gap flux which is sinusoidally distributed. The stator has 5 slots per pole per phase and each slots contains 4 conductors arranged in two layers. The coil pitch is 12 slots, with normal excitation and rated speed, the voltage induced per conductor is 25 V. The open circuited emf of this Y-connected machine between lines is?
A synchronous generator is connected to a pure capacitive load. The field excitation is kept constant and the stator resistance is assumed negligible. Explain, with the help of phasor diagram(s), how the generator’s terminal voltage will vary when the capacitive load is increased while the power factor is kept constant.
Please solve this problem step by step and illustrate your answer properly. Write your answer in a piece of paper please. Box the final answer.
Two identical 2,000 kW alternator operates in parallel. The governor of the first machine is such that the frequency drops uniformly from 50 Hz at no-load to 48 Hz at full-load. The corresponding uniform speed drop of the second machine is 50 Hz to 47.5 Hz. What is the maximum load that can be delivered without overloading either machine?
A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing 5 conductors arranged in a full-pitched winding for 3-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emf induced in each phase winding and the terminal voltage.