1- A steam turbine receives (600 kg/hr) of steam at (25 bar, 350 C°). At a certain stage of the turbine, steam at the rate of (150 kg/hr) is extracted at (3 bar, 200 C°). The remaining steam leaves the turbine at (0.2 bar, 0.92 dry). During the expansion process, there is heat transfer from the turbine to the surroundings at the rate of (10 kj/s). Determine the power produced by the turbine.

1- A steam turbine receives (600 kg/hr) of steam at (25 bar, 350 C°). At a certain stage of the turbine, steam at the rate of (150 kg/hr) is extracted at (3 bar, 200 C°). The remaining steam leaves the turbine at (0.2 bar, 0.92 dry). During the expansion process, there is heat transfer from the turbine to the surroundings at the rate of (10 kj/s). Determine the power produced by the turbine.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

14 thermodynamics
A reheat cycle with two stages of reheating is executed with steam expanding initially from 25 MPa and 600 °C. The two reheater pressures are 4 MPa and 1 MPa, and the steam leaves each reheater at 600 °C. Condensation occurs at 40°C. For 1 kg/s of steam, what is QA in kW? Remember, 1. For values taken from the steam tables: Use them as is, do not round off. 2. For values obtained by interpolation and final answers obtained by solving, use FOUR (4) decimal places. 3. Use the steam tables provided
Q3: Air undergoes a three-process cycle. if the processes are :1→ 2: constant- pressure expansion .2→ 3: constant volume 3 → 1: constant-temperature compression .The necessary information is T1 = 100°C, T2 = 600°C, and P1 = 200 kPa. R=0.287 KJ/kg.K 1) Find the net work done for 1 kg A: 32.5 KJ B: 42.5 KJ C: 52.5 KJ D: 62 KJ
13. During a reversible process, 2.09 kg/s of gas rejects 322.9 kJ/s of heat isothermally at 25.5°C. For this gas, cp = 2.14 kJ/kg K and c, 1.62 kJ/kg K. The initial pressure is 551.7 kPa. Determine the work steady flow of the process in hp if APE = 2.8 kJ/s and AKE = 6.2 kJ/s.
1
1. Combustion gases enter the nozzle of a jet engine at 3.8 bar and 820°C. The nozzle is well insulated and the gases expand down to an exit pressure of 1.1 bar. Determine the temperature and the velocity of the gases at exit from the nozzle assuming the velocity at inlet is negligible. For the combustion gases take c, = 1.15 KJ/Kg. K and the ratio of specific heats = 1.32
1. A 5,000 kg/min of water at 35°C enters a cooling tower where it is to be cooled to 20 °C. The energy is to be exchanged with atmospheric air entering the unit at 16°C and leaving the unit at 32°C. The air enters at 35% RH and leaves at 80% RH: If all process are assumed to occur at atmospheric pressure, determine the percentage of total water flow that is makeup water. 2. A 45 GPM of water enters a cooling tower at 50°C. Atmospheric air at 14°C and 50% RH enters the tower at 3.5 m and leaves at 25°C saturated. Determine the volume of water that leaves the tower.
As shown in the figure, a 320-ft³ tank contains 25 lb of H₂O initially at 30 lbf/in². The tank is connected to a large steam line carrying steam at 200 lbf/in², 450°F. Steam flows into the tank through a valve until the tank pressure reaches p2 = 100 lbf/in² and the temperature is 400°F, at which time the valve is closed. Step 1 Steam at 200 lbf/in.2, 450°F Am 12 = i (1) Valve AD Determine the amount of mass that enters the tank, in lb. lb (1) Determine the amount of mass that enters the tank, in lb, and the heat transfer to the tank from its surroundings, in Btu. Tank Initially: 30 lbf/in.², m₁ = 25 lb (2) Finally: P₂ lbf/in.², 400°F.
A power plant operates in an idealized Rankine cycle, using water as the working fluid (Figure 3). The steam at the exit of the boiler has a pressure of 6 MPa and temperature of 600 °C (point 1). The water at the exit of the condenser has a pressure of 15 kPa (point 3). The condenser employs a nearby river as the cooling source, which can be regarded to have a constant temperature of 25 °C. The mass flow rate of the steam is 80 kg/s. The hot reservoir has a temperature of 1400 K. Regard water as an incompressible liquid. During pumping, the density of water remains unchanged as Point 3 in Figure 3. Qin Boiler i wwwwww Pump Turbine Wp 3 Figure 3 W₁ Cooling water Condenser
A fluid at 0.5 bar occupying 0.08 m3 is compressed reversibly to a pressure of 10.9 bar and specific volume of 0.6 m3/kg according to the law pvn = c. The fluid then expands reversibly according to the law pv2 = c to 1.6 bar. A reversible cooling at constant volume then restores the fluid back to initial state. Calculate the net work for the process in Joules.
20. A certain gas steadily flows through a engine at constant temperature of 400 K. The exit pressure is one-third of inlet pressure of 2.07 kg/cm². If AP = 0, AK = 0, the work of steady flow is, a-126 b-128 c 128 d 126
T-8