1-106. The bearing pad consists of a 150 mm by 150 mm block of aluminum that supports a compressive load of 6 kN. Determine the average normal and shear stress acting on the plane through section a-a. Show the results on a differential volume element located on the plane. a 30° 6 kN 150 mm a

Q: Forces are applied at points A and B of the solid cast-iron bracket shown. The bracket has a…

A:

Q: The 50-mm diameter circular rod creates in the metal sheet a shear stress through section AC and BD.…

A:

Q: 2. The structure is used to support a distributed load of w = 5 kN/m. The bolts at A, B, and C each…

A:

Q: (6) The tension member is fastened together using two bolts, one on each side of the member as…

A:

Q: A steel bracket of solid circular crosssection is subjected to two loads, each of which isP = 4.5 kN…

A: Given:- The magnitude of the force (P) = 4.5 kN The dimension variable (b) = 240 mm = 0.24 m The…

Q: d help wirh 3 and

A:

Q: A single strain gauge, placed in outer surface and at an angle of 30 gives a reading at point A of…

A:

Q: 1. A sign structure is subjected to the uniform wind loading of 2 kPa. Determine the stress…

A:

Q: A T-beam with the cross-section shown above is subject to the loads shown. a) Determine the second…

A: Given:- To find:- Second moment of area SFD and BMD Normal stresses at A, B and C Concept:-…

Q: 06. The lap joint is connected by three 20-mm diameter rivets. Assuming that the axial load P = 50…

A:

Q: Calculate the maximum tensile and compressive stresses in the section of BC of the beam. A 0.5 in…

A: Determine the maximum tensile and compressive stress in the section BC.

Q: Determine the principal stresses acting at the 1 section using Mohr circle

A: Determine the area of the section. The area of the section is A A=150 mm5 mm+180 mm6 mm+200 mm8…

Q: PROBLEM 2 Strips A and B are to be glued together using the two strips C and D. a. Determine the…

A: force transfered by C strip = Force in D strip=force in A strip 2=20 KNlet the width of the strip C…

Q: Assume that the clamp shown has been tightened on wooden planks being glued together until P = 420…

A:

Q: load of 6 Kn IN Figure 3. Determine the average normal and shear stress acting on the plane through…

A: given- a bearing pad of aluminum that carries a compressive force of 6kn  required- to find average…

Q: The strain at point A on the bracket has components = 330 (10-), ey = 560 (10-). Yxy = -570 (10-0).e…

A: Data given εx = 330×10-6 εy = 560×10-6 εz = 0 γxy = 570×10-6 To find:- Maximum shear strain…

Planar Stresses