0.5 in. -d--> -5 in.--d 8 The vertical shear is 1200 lb in a beam having the cross section shown. Knowing that d = 4 in., determine the shearing stress at (a) point a, (b) point b. 8 in. 4 in. 0.5 in. Fig. P6.38 and P6.39

Q: Draw the shear and moment diagram for the beam shown below by choosing the reaction at the interior…

A:

Q: Prob. 2.7-8. An angle bracket ABC is restrained by a high- strength steel wire CD, and it supports a…

A:

Q: 100 kN 100 kN E |D 35 kN 3 m C 7 m В 4 m -3 m- -3 m- 4 m-

A:

Q: 4.9 through 4.11 Two vertical forces are applied to a beam of the cross section shown. Determine the…

A:

Q: Determine the support reactions and all internal pin forces.

A:

Q: L - 25 in. - 25 kips For the beam and loading shown, determine:. 5. The shearing stress at point a (…

A:

Q: *7-60. The built-up beam is formed by welding together the thin plates of thickness 5 mm. Determine…

A: Answer The shear centre  lies on the axis of symmetry and divides the distance between the C.G's of…

Q: 11-95. The beam has the rectangular cross section shown. If w = 1 kN/m, determine the maximum…

A: Given: The value of w is 1 kN/m. Consider the figure,

Q: 1. For the frame and loading shown, (a) determine the forces acting on member BC at B and C.…

A: Given:- To find:- Force at B and C in member BC Shear force, axial force and bending moment at D…

Q: Determine the maximum shear stress in the T-beam at section C. Show the result on a volume element…

A: Solution:

Q: A |C 3 m- +1.5 m→1.5 m→| 150 mm

A: Let maxi distributed load on the beam is Wthenreactions and shear force…

Intersection Design

An intersection is a location where two or more roads or railways meet or join. The traffic movement is controlled at the intersection that depends on its design and type. It governs the operation, efficiency, speed, capacity, and safety of the highways, airways, and railways. The movement of the pedestrian causes hazards and delays at the intersection.