. A homogeneous rod of constant cross section is attached to unyielding supports. It carries an axial load P applied as shown in the figure. Prove that the reactions are given by RI = Ph/L and R2 = Pa/L. (Note that these reactions are equivalent to those of a simply supported beam carrying a concentrated load). P R2 - a L -

Q: Figure Q3a shows a simply supported beam AB with support reactions RA and RB. Two point loads F₁ =…

A: To find  : The reaction RA and RB . Given :  The forces are F1=35 kN and F2=65 KN. The length are…

Q: The beam in the figure below is subjected to a load P=2 kN at its end. Young's modulus is 210 GPa…

A:

Q: The rigid beam in (Figure 1) is supported by the three suspender bars. Bars AB and EF are made of…

A:

Q: 4- For the beam shown in Figure, determine the displacements and the slopes at the nodes, the forces…

A: Given:To find:(a) Displacements and the slopes at the nodes.(b) Forces in each element.(c) Reactions…

Q: The beam shown in Figure Q.2 consists of a W610 x 140 structural steel wide-flange shape [E = 200…

A:

Q: Q.3 A steel column (E = 30 x10 3 ksi) that is fixed at the base and free at the top is constructed…

A:

Q: The cantilever beam in the figure has a fixed support at A and is under the actions of a uniformly…

A:

Q: Q2/ A beam (ABC) is supported at A&B and carries a uniformly distributed loads between AB of 50N/m…

A: Here we will apply equilibrium conditions

Q: y 300 400 N 500 -Bar, b = 6, h = 32 B 300 400 N C x

A:

Q: 3. An I beam column with fixed ends (at x = 0 and x = 12 m) is braced at midpoint C as shown below…

A:

Q: 1. The cantilever beam shown in the following figure is subjected to a load P or a deflection & at…

A: Cantilever beam length (L): 14 inchesLoad at the free end (P): 6 lbfYoung's Modulus (E): 30 10^6…

Q: The beam shown in Figure Q.2 consists of a W610 x 140 structural steel wide-flange shape [E = 200…

A:

Q: he beam is subjected to a point load and a distribution load as shown in Figure 2-1 below, and the…

A:

Q: In the figure below, a lug wrench is subjected to loads as shown. The tool body is a hollow cylinder…

A:

Q: 1. The frame ABC, supported by a clamp at A and a roller at C, will be used to support a distributed…

A: Dear students

Q: The lower ends of the members of a 4-bar pined-joint truss shown in the figure below are fixed in…

A: Solution: Given Data: A→8,0,0B→0,10,0C→-8,0,0D→0,-5,0O→0,-20,20   To Find:

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.