Assignment #6 Week #6

Alert for not submit AI generated answer. I need unique and correct answer. Don't try to copy from anywhere. Do not give answer in image formet and hand writing

Kindly answer all the questions being asked. I will rate "like/upvote" your post if you answer all of the questions; if not, then i will "unlike/downvote." Please show complete solution and clear explanation. Choose from the choices for the correct answer. Thank you.

answer a & b. Please show all your work!!

Case Study: Paula’s Pain Paula has worked for Brindle Corporation for 3 years.  During this time, she has worked as a machine operator/cell leader in various work cells.  Recently, the plant went to mandatory 12-hour shifts and plans to remain on this schedule for several months. Paula’s present work cell is manufacturing 3-inch diameter exhaust tubes that are made from stainless steel.  These tubes get a hole punched in them, a flange welded on, and burrs ground off.  The pipe then gets placed into a gage to check that it was made correctly.  (The tubes weigh about six pounds.) Paula has been performing the welding operation.  She leans into the machine and loads the part into a fixture then positions the flange.  Both pieces are clamped (using hand clamps) into position and the machine is cycled by depressing two palm buttons. The gaging operation requires placing the finished part into the gage and clamping it (using hand clamps) into place. A pin is depressed to verify the position…

No gpt,solve in paper sheet. Free body diagram is must and should.

reply to the jobsite owner effectivlr and clearl   I would like to explore the possibility of using a lighting control system. There are times when office staff works long hours and researchers sometimes need to be in the building on nights and weekends. Often times they leave the lights on which increases my electricity costs. I would like to be able to program the lights on a schedule and if the staff needs to work outside that schedule they could request a change with our maintenance staff ahead of time. Could you please look into this and provide me with some potential options.  Regards-Owner

Please Asap

Hello. I just want to make sure the answers I chosen on the image attached are correct because I am unsure.

Please solve the Problem 4 elaborately, use other shortcut Methods you have or you may Solve both or in more different methods the better ?. Your solution will be use as reference for my Future Board Exam preparation/review/study. Thank you so much dear your work will be appreciated much and rated excellently.

Create a Refrigeration Cycle Steps: You can start at an point in the cycle in the picture, but you must follow this order and you must make it through the entire cycle. The following must be included also and explained /defined Evaporation, Condensation, Fan for the Condenser and Blower for the evaporator. Provide good information

This is a practice hw question not graded!!

Task3

Instructions: dont use Chatgpt ok. Use clean handwriting with Diagrams solution u can answer latex also woth Diagram. No need generalized answer ok. If u dont follow my instructions i will dislike direct ok. Thanks

1. Given the two views of a multiview drawing of an object, sketch the missing top view on paper. Create SolidWorks part models. Compare the top views of the SolidWorks models with your sketch. Each grid is 0.25 inch. (Do not to submit the sketch.) Submit Solidworks part models on Sac CT.

4. Which object snap is selected to snaps to the middle point of two selected points. 5. Which object snap is selected to snaps to four key points located on a circle. 6. Which button of Line Property Manager Button is clicked to delete a layer?

Please explain all parts and which formulas to use