Screenshot 2023-11-04 at 2.12.37 PM

I REPEAT!!!!! I NEED HANDDRAWING!!!!! NOT A USELESS EXPLANATION!!!! I REPEAT SUBMIT A HANDDRAWING IF YOU CANNOT UNDERSTAND THIS SKIP IT !  I need the real handdrawing complete it by adding these :  Pneumatic Valves Each linear actuator must be controlled by a directional control valve (DCV) (e.g., 5/2 or 4/2 valve). The bi-directional motor requires a reversible valve to change rotation direction. Pressure Regulators & Air Supply Include two pressure regulators as per the assignment requirement. Show the main compressed air supply line connecting all components. Limit Switches & Safety Features Attach limit switches to each actuator to detect positions. Implement a two-handed push-button safety system to control actuator movement. Connections Between Components Draw air supply lines linking the compressor, valves, and actuators. Clearly label all inputs and outputs for better understanding.

Answer questions 1 and 3 and 5 in full detail please

Match the following terms with the definitions.Damping Bandwidth End point Home position Holding torque Traverse rate   The desired location to which a load is moved The speed at which a load is moved from one location to another A measure of how quickly the actuator responds to the command signal Prevention of overshooting The force that causes the load to maintain a standstill position A reference point from which a load is measured

Use time delay A push button is to control the forward stroke after the piston rod has reached the forward end position the components are to be pressed together for 20 seconds then the piston rod is to return automatically to the initial position Additional condition The return stroke must occur even if the start push button is still depressed A new start signl may only become effective after the initial position has been reached and after the push button has been released

19) Get a kinematic diagram (schematic view) equivalent to the following mechanism and its degree of freedom.

1. What is the MMC of the ø68 mm boss? and what is the position tolerance on the boss referenced at MMC, LMC, or RFS? 2. How much position tolerance is allowed on the boss if it is produced at a size of 68.1 mm? And what is the MMC of the 3 holes?   I'm slightly confused on how to do these. Please refer to the image attached for reference.

very urgent i need her solving all part pls quickk (mechanical system)

How long will it take the vibration table to do a sine sweep from 2 to 256 Hz at a rate of 2 octaves/minute?

i need the answer quickly

Problem Description Components are to be continuously stamped with a stamping device. After the start button is pressed, the die is pushed down and the component is stamped. The die is to return to initial position after five (5) seconds. The sequence stops automatically after five (5) cycles. Start button should reset the counter. Inductive sensors S1 and S2 are used to check the fully retracted and extended positions of the cylinder. Draw the following: Pneumatic circuit diagram Electrical circuit diagram

The state of an object varies over time, but at any particular points it is determined by:   Which is correct? A. the object attribute values B. the relationship it has to other objects C. All of these D. None of these