Hazard Inspection Checklist

Select whether the following statement's are true or false: Structural safety is solely the responsibility of the aircraft manufacturer and the airworthiness authorities. If a structural component is not inspectable, it can still be certified according to one of the available design philosophies. Decreasing the stress amplitude while maintaining the mean stress means that less work or energy is applied to the structure, and thus less damage is caused resulting in a longer fatigue life.

Question 2 1. What is a First Article Inspection and why it is needed? Explain briefly (with the help of the following drawing)the steps that you take to prepare FAI in terms of design, manufacturing, and inspection of any part First Article Inspection Requirements RAW MATERIAL DRAWINGS, STANDARDS, SPEC SHEETS SPECIAL PROCESSING REQUIREMENTS TEST SPECIFICATIONS PROCEDURES SPECIAL PROCESSES (ANODIZATION, CLEANING ETC,). RAW CONVERSION FUNCTIONAL MATERIALS PROCESSES (MACHINING, CASTING ETC.) TESTING (AL6061 T6, 301SST etc.) CERTIFICATE OF CONFORMANCE TEST CERTIFICATE OF CONFORMANCE DIMENSIONAL MEASUREMENTS RESULTS MANUFACTURING ENGINEERING

A vehicle's Maximum Gross Weight (MGW) can be found on the New York State registration and is used to determine what type of safety inspection is done on a vehicle. True or False?

Which tool helps to categorise risks into three colour-coded zones representing major, moderate, and minor risks Risk Priority Number Risk assessment matrix Failure Mode and Effects Analysis O Severity Matrix

In the event of a spill of gearbox oil in the workshop, what workplace health and safety procedures should be followed? In your answer list the document (including any relevant sections) that would provide the most accurate source of information for safely managing the spill. Identify one (1) key difference in control measures between a large and a small spill.

A person is required to perform a lifting task. After conducting the analysis of the task shown below using the NIOSH lifting guidelines you determined that the task need to be redesigned to be acceptable. Unfortunately, the only factor that you can modify is the frequency of lifts per minute. What is the maximum number of lifts per minute that need to be used for this task so the NIOSH lifting guidelines are not exceeded?   ANSWER:  ________________

Describe some of the measures to achieve the maintenance objectives.

What are the factors that the organization must consider when adopting the maintenance strategy?

OR Perform FMEA and Root Cause Analysis for any TWO problems faced in your industry. MA

industrial maintenance What is the most common unsafe act?

The possibility for Occidental mechanical damage in the automotive shop isA nonexistent B rare  c always present d none of the answers listed Foam fender covers are usually about how thick 0.0625 0.125. 0.25 0.375. The best way to minimize, accidental mechanical damage is two Think carefully about the task or work you're performing Replace as many components as possible Follow you experience when  repairing a vehicle

All the following statement about predictive maintenance are correct except one. Which one? In predictive maintenance, it is key to define a clear monitoring system O Ultrasonic testing and liquid penetrant dye testing can be used to detect whether the equipment/parts of the equipment has/have cracks. O Predictive maintenance can contribute to reduce production downtime. O In predictive maintenance, components are inspected regularly and only components which aren't in a good working order are restored. Predictive maintenance allows to schedule for repair any piece of equipment that is trending towards failure.

An accident investigation report must include all of the following except: The date of the accident Names of those witnessing the accident A description of the incident Factors that contributed to the incident