SCI 100 Module Six Activity

DEGREE: Electrical Engineering SUBJECT/COURSE: AC CircuitsTOPIC: Converter and Rectifier NOTE: Please solve in this way. 1. Please have a good handwriting, some of the answers are not readable. Thank you!2. GIVEN. (Include symbols and units)3. REQUIRED/FIND/MISSING (with symbol/s)4. ILLUSTRATION (Required).5. Step-by-step SOLUTION with Formulas and Symbols. No Shortcut, No skipping, and detailed as possible6. FINAL ANSWERS must be rounded up to three decimal places PROBLEM:A three-anode mercury-arc rectifier supplies a 250-kw 230-volt load and is energized from a 4,600-volt three-phase source through a three-phase transformer whose primaries are in delta. Assuming an arc drop of 20-volts, calculate:(a) the d-c load current;(b) the voltage and kilovolt-ampere rating of each transformer secondary;(c) the current and kilovolt-ampere rating of the three-phase transformer.

I have a wooden toy train that runs on wooden tracks. I would like to place two ESP-WROOM-32 Boards on top of the train. Broadcast communication (which involves radio frequency, not Wi-Fi) would help communicate about the train's lateness to five other wooden trains on the same track. Local communication would help communicate to the train station about the train's lateness. I would also need radio frequency Tx-Rx Modules for discharging and undergoing the signal, and repeaters just in case the signal loses power due to long-distance traveling. My wooden train should be automated. It should run at 4 inches per second, keep a minimum distance of 30 seconds away from the other wooden trains, and make a 17-second-long stop every 500 seconds. What's the procedure to connect the components? What's the Arduino code (C++) for this project?

I have an O Gauge track and would like to convert it into a “sensored” track. Additionally, I would like to connect that track to an ESP-WROOM-32 board that should flash an LED whenever the track detects a non-moving train. Please list all the components (and how many of each) needed. Also, what’s the procedure for connecting the components?

Sir, I need more details. Thanks

1- Draw the complete circuit diagram that illustrates the experiment concept as in figure 5 by showing the pins number. Show the following in your plot (Arduino board, steppermotor coils and the driver circuit). Note: The drawing should be on paper and not with artificial intelligence, please.

Answer all the items. Thanks!

DEGREE: ELECTRICAL ENGINEERING  SUBJECT/COURSE: AC CIRCUITS   NOTE: Please solve in this way.    1. Please have a good handwriting, some of the answers are not readable. Thank you! 2. GIVEN.(include symbols and units) 3. REQUIRED/FIND/MISSING (with symbol/s) 4. ILLUSTRATION (Required). 5. STEP-by-STEP SOLUTION with Formulas and Symbols. No Shortcut, No skipping, and detailed as possible 6. FINAL ANSWERS must be rounded up to three decimal places   PROBLEM: • An abc-phase sequence three-phase balanced wye-connected source supplies a balanced delta-connected load. The impedance per phase of the delta load is 10+j8 Ω. If the line impedance is zero and the line current in a phase is known to be la=28.10<-28.66° Arms, find the load voltage Vab.