EECE 301 NS_14 In-Class Problems

As part of a radio receiver, you are asked to design a simple bandpass filter using a series inductor, capacitor and resistor. The filter needs to pass a centre frequency of f0 = 1089 kHz with a bandwidth of 9 kHz. Do this by finding the capacitor and resistor values together with a 240 uH inductor that will give you the correct centre frequency and bandwidth. Also, calculate the quality factor Q for your filter. Sketch the filter circuit and show all your calculations.

I need some help. I am designing a bandpass filter with fl=3400 Hz and fh= 7500 Hz. Based on that I need the values for the RCL circuit, assuming that the capacitor is 1 microfarat. So, I need some help in calculate the center frequency, bandwith, Q, center frequency as well. I need clear steps and calculations. Any help will be appretiated.

Answer the following wuth illustration and solutions. 1.) A second-order band pass filter is to be constructed using RC components that will only allow a range of frequencies to pass above 500Hz and below 1.5kHz. Assuming that both the resistor have values of 1kohms, calculate the values of the two capacitors required. Find also the center frequency of the two frequencies. This is the example/guide that might help.

2. The circuit of the Figure is a notch filter. Generate a magnitude plot of the transfer function H(f) = Vout/Vin with frequency ranging from 10 Hz. to 100 kHz. Then, analyze the circuit at very high and very low frequencies to provide checks on the plot. Use the plot to determine the frequency of maximum attenuation and the value of the transfer function at that frequency. Hint: Use the phasor transformation. www R₁ R₁ = 90 92 R₂=1022 R₂-100 £2 0000 L ww R₂ L = 100 mH C=0.1 μF www Ry Vout

Figure P6.16 shows the input and output voltages of a certain filter operating in steady state with a sinusoidal input. Determine the frequency and the corresponding value of the transfer function.

I need the full answer with explain please

Answer the following with illustration and solutions. 2. Design a basic wide-band, RC band stop filter with a lower cut-off frequency of 250 Hz and a higher cut-off frequency of 1.2kHz. Find its center frequency, bandwidth and Q of the circuit assuming the capacitor for both filter sections is 0.1 microfarad. Thia is the example that might help.

Asap please

an ideal low pass filter with a cutoff frequency of 46KHZ, is fed by the periodic signal shown in the figure, determine. Plot the spectrum of the periodic signal