Week 2 Worksheet 26104 Ohms Law completed

QUESTION 1 What practical skills were taught and assessed in you Electronic Engineering lab? Choose one or more correct answers in the following list: A. Soldering electronic components on a PCB B. Working principles of a semiconductor diode. C. Electronic PCB design D. Soldering an IC on a PCB E. De-soldering surface mount component techniques F. Cleaning the soldering iron tip

A semiconductor is a material that has _____ energy band gap. a)no b)wide c)narrow d)nuclear

Centennial College - School of Engineering Technology - Toronto ELECTRONICS SHOP PRACTICES CHAPTER 7: SOLDERING TECHNIQUES 7,5 QUESTIONS 1. Which tools will you need for soldering? 2. What type of solder do we call the Eutectic Solder? 3. If the temperature is too high, the is bellow required, the solder joint will appear cold and silvery and will be of the contact may occur and circuit will not work. If the 4. A long and sharp will be of little use when soldering wires or 5. The iron should have a tip to prevent and should have a wattage rating of to Watts. 6. When soldering, apply heat solder will to both, the component lead and much more readily over the copper pad so that the 7. Keep the soldering iron tip and working surfaces wipe only before using and immediately. 8. Do not solder from a heated tip before off the iron. alternate applying the surface. 9. If tips become and wiping to being used. 10. Periodically. the tip from your tool and with a suitable cleaner for your skills.…

Answer question clearly and fully. Make sure I can properly read out the steps. Include any and all equations used during the solving process.

I need the answer as soon as possible

The working voltage of a battery is defined as the voltage at the battery terminalsA. while float charging.B. while the battery is being tested.C. while the battery is being discharged.D. while the battery is being charged.

please answer all questions and give me a sample ansowers 1. What code sets standards for electrical installation work? 2. What authority enforces the requirements set by the NEC? 3. Does the NEC provide minimum or maximum standards? 4. What do the letters “UL” signify? 5. What section of the NEC states that all listed or labeled equipment shall be installed or used in accordance with any instructions included in the listing or labeling? 6. When the word “shall” appears in a NEC reference, it means that it (must)(may) be done. (Underline the correct word.) 7. What is the purpose of the NEC?

Please explain whether NEC provides maximum standards or minimum standards?

1. Explain with a neat block diagram the measurement of temperature using RTD (measuring system).

Please answer in typing format

State the main constituent elements of electrical cables, as well as the materials from which they may be made. Describe the following designations: H05VV-U 1G4 mm? and LSXAV 3x16 mm?.