Module 08 - Chapter 08 Assignment

docx

School

Stephen F Austin State University *

*We aren’t endorsed by this school

Course

314

Subject

Computer Science

Date

Feb 20, 2024

Type

docx

Pages

2

Uploaded by JudgeUniverse8370

Report
Stephen F. Austin State University INDS 1325 - Introduction to Dr. Nathaniel B. Walker, IV AutoCAD Spring 2023 HMSS - Rm. #108 Chapter 8 - Site Plan NAME: Yamilex Valdez Add your name to this assignment. Do not change the format of this document. Highlight your responses in yellow for multiple choice questions and type your responses in red for fill-in-the-blank responses. Failure to follow these instructions might impact your grade for this assignment. 1. A grade profile can help to calculate the amount of cut and fill required. A. Ture B. False 2. Scaling and rotating the tree blocks as they are inserted helps to make the drawing look more natural (less like a cookie-cutter). A. True B. False) 3. A swale helps to direct the flow of surface runoff on a site. A. True B. False 4. With the Pedit command, the Fit _______________ sub-command makes a smoothed-out polyline that maintains the points you picked to draw the contour; whereas the Spline _________________ sub-command allows the polyline to deviate from your original points. 5. Layers associated with an Xref have what as a name prefix? File name _____________ 6. You need to set which property of a polyline to “enabled” to make the dashes consistent: Line type generation _________________ 7. When a “lower” (e.g., 1060′) contour is rerouted to move closer to a “high” (e.g., 1065′) contour, the contractor would have remove ______________ earth. 8. After picking your first point, type the Command window instructions to draw a line 321.125′ long with an angle of 43°12′ (ccw off the horizontal): @ 32.125’ _________< 43degree12’ ___________. 1 | P a g e
Stephen F. Austin State University INDS 1325 - Introduction to Dr. Nathaniel B. Walker, IV AutoCAD Spring 2023 HMSS - Rm. #108 9. To draw a solid black dot with a 24″ diameter you would use the Donut command with the “inside radius” set to 0″ and the “outside radius” set to 12. A. True B. False 10. What Layer does the building outline go on? C- BLDG ___________________ 2 | P a g e
Your preview ends here
Eager to read complete document? Join bartleby learn and gain access to the full version
  • Access to all documents
  • Unlimited textbook solutions
  • 24/7 expert homework help