In Figure D-8a and D-8b, every region of constructive interference and destructive interference between the HOMO and LUMO is to be labeled. Concept introduction: Molecular orbitals are constructed from the AOs of different atoms. When two atoms are brought close enough together (i.e., about a bond length apart), the AOs of one atom significantly overlap the AOs of the other atom, enabling them to undergo constructive and destructive interference, or mix, to produce new orbitals. When two orbitals overlap with the same phases, constructive interference takes place. When two orbitals overlap with the opposite phases, destructive interference takes place. Constructive interference results in a new orbital that is more stable than the σ bonding orbital, and destructive interference results in a new orbital that is less stable than the ρ atomic orbital. Constructive interference predominantly takes place in both Figure D-8a and Figure D-8b.

Question

Want to see the full answer?

Answer 1

Question

Chapter D, Problem D.10YT

Interpretation Introduction

Interpretation:

In Figure D-8a and D-8b, every region of constructive interference and destructive interference between the HOMO and LUMO is to be labeled.

Concept introduction:

Molecular orbitals are constructed from the AOs of different atoms. When two atoms are brought close enough together (i.e., about a bond length apart), the AOs of one atom significantly overlap the AOs of the other atom, enabling them to undergo constructive and destructive interference, or mix, to produce new orbitals. When two orbitals overlap with the same phases, constructive interference takes place. When two orbitals overlap with the opposite phases, destructive interference takes place. Constructive interference results in a new orbital that is more stable than the σ bonding orbital, and destructive interference results in a new orbital that is less stable than the ρ atomic orbital. Constructive interference predominantly takes place in both Figure D-8a and Figure D-8b.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Reaction Fill-ins Part 2! Predict the product(s) OR starting material of the following reactions. Remember, Hydride shifts are possible if/when a more stable carbocation can exist (depending on reaction mechanism)! Put your answers in the indicated boxes d. d. ง HCI

A cylinder contains 12 L of water vapour at 150˚C and 5 atm. The temperature of the water vapour is raised to 175˚C, and the volume of the cylinder is reduced to 8.5 L. What is the final pressure of the gas in atmospheres? assume that the gas is ideal

On the next page is an LC separation of the parabens found in baby wash. Parabens are suspected in a link to breast cancer therefore an accurate way to quantitate them is desired. a. In the chromatogram, estimate k' for ethyl paraben. Clearly indicate what values you used for all the terms in your calculation. b. Is this a "good" value for a capacity factor? Explain. c. What is the resolution between n-Propyl paraben and n-Butyl paraben? Again, indicate clearly what values you used in your calculation. MAU | Methyl paraben 40 20 0 -2 Ethyl paraben n-Propyl paraben n-Butyl paraben App ID 22925 6 8 min