The cause for prepared solution concentration is not to be exactly 0.1 M should be found from the given options. Concept introduction: Steps involving standard solution preparation: The steps involving in the preparation of known molar solution using volumetric flask are, The calculated mass of the solute is weighed in the balance and the weighed solute is transferred in to the volumetric flack. Then small quantity of water is added in to the volumetric flack and shaken to dissolve the solute. After dissolving solute particles, water is poured into the volumetric flack to reach the mark. Errors in standard solution preparation: Incorrect weight of solute makes a concentration change in final solution. Loss of solute particles results lower the concentration of final solution. Before the addition of solute, if water is filled in the volumetric flask to reach the mark, the resulting volume changes (increasing of volume) in final solution, this volume changes makes concentration decreases. Neglecting addition of last bit of water into volumetric flask to reach the mark results in lower volume than the calculated volume.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 9.3VC

Interpretation Introduction

Interpretation:

The cause for prepared solution concentration is not to be exactly 0.1 M should be found from the given options.

Concept introduction:

Steps involving standard solution preparation:

The steps involving in the preparation of known molar solution using volumetric flask are,

The calculated mass of the solute is weighed in the balance and the weighed solute is transferred in to the volumetric flack. Then small quantity of water is added in to the volumetric flack and shaken to dissolve the solute. After dissolving solute particles, water is poured into the volumetric flack to reach the mark.

Errors in standard solution preparation:

Incorrect weight of solute makes a concentration change in final solution.

Loss of solute particles results lower the concentration of final solution.

Before the addition of solute, if water is filled in the volumetric flask to reach the mark, the resulting volume changes (increasing of volume) in final solution, this volume changes makes concentration decreases.

Neglecting addition of last bit of water into volumetric flask to reach the mark results in lower volume than the calculated volume.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Draw the stepwise mechanism for the reactions

Part I. a) Draw reaction mechanism for the transformations of benzophenone to benzopinacol to benzopinaco lone b) Pinacol (2,3-dimethyl, 1-3-butanediol) on treatment w/ acid gives a mixture of pina colone (3,3-dimethyl-2-butanone) and 2, 3-dimethyl - 1,3-butadiene. Give reasonable mechanism the formation of the products For

3. The explosive decomposition of 2 mole of TNT (2,4,6-trinitrotoluene) is shown below: Assume the C(s) is soot-basically atomic carbon (although it isn't actually atomic carbon in real life). 2 CH3 H NO2 NO2 3N2 (g)+7CO (g) + 5H₂O (g) + 7C (s) H a. Use bond dissociation energies to calculate how much AU is for this reaction in kJ/mol.