A flexible foundation is 2 m x 4 m rests on granular soil at ground level. It carries a uniformly distributed load of 160 kN/m2. The sand has an elastic modulus of 39 MPa , a Poisson's Ratio of 0.3 and is 5 m thick. Estimate the elastic settlement below the center of the loaded foundation. Give your answer in cm rounded to 2 decimal places.

A mat foundation, 15 m x 15 m, is made of reinforced concrete and to be supported by a three-layer soil profile, as shown. The mat is 1 m thick, and the average stress on the surface of the slab assessed from the structural engineering analysis is 75 kPa. (Unit weight of concrete = 23.58 kN/m^3) The 5-m thick sand layer immediately below the mat foundation has been compacted to standard Proctor specifications, most likely to optimum moisture content, which is why its moist density is given. (A) Determine the pre-construction effective stress at Point A (bottom of the clay layer). This is the in situ effective stress (overburden pressure) measured from the ground surface prior to the placement of the mat foundation. (B) Determine the vertical stress increase induced by the mat foundation at Point A using the “Influence Chart,” commonly referred to as the “Spider Web.” (C) Determine the vertical stress increase induced by the mat foundation at Point A using the “Stress Isobars.” (D)…

The attached figure shows the plan of rectangular foundation which transmits a uniform contact pressure of 120 kN/m2. The width of the foundation is 15 m. A)  Determine the increase in vertical pressure at a depth of 10 m below point A B)  The vertical stress at a depth of 10m below point B

The subgrade reaction of a sandy soil obtained from the plate load test (plate dimensions 1 m × 0.7 m) is 18 MN/m3. What will be the value of k on the same soil for a foundation measuring 5 m × 3.5 m?

Estimate the increase in vertical stress at 0.5 m depth intervals, within the clay layer, below point A (See figure below). The foundation exerts a uniform vertical stress of 120 kPa at ground level. Using these values estimate the settlement due to the clay layer. (Hand in any graphs used) 5m 5m 2m 3m Very Dense Sand 2m 1.5m Clay E=3.5 MPa 2m Bedrock Soil profile A Plan of building 3m Soil profile and plan for Question 4 3m FA

A circular foundation (D = 6 m) is built on a construction site where the soil profile is shown in Figure 5 below. The circular foundation applies a uniform pressure of 80 kPa to the surface of clay. The properties of the clay are: Specific gravity, G₁ Saturated unit weight at Compression index Ce Recompression index Cr Consolidation coefficient, c Over-consolidation ratio, OCR 10 m 6m Ø Clay Impervious rock Figure 5 2.6 20 kN/m³ 0.25 0.10 2.5 m²/year 1.2 (b) Calculate the stress increase at the center of the clay layer and 1) beneath the foundation center and 2) beneath the edge of the foundation; (c) Calculate the consolidation settlement beneath the center of the foundation due to the stress increase; (d) Determine the settlement at the center of the clay after 1 year of applying the pressure; (e) A 50 mm thick clay sample was taken from the site and consolidated in the oedometer, how long it will take for the clay to reach 90% consolidation?

The initial principal stresses at a certain depth in a clay soil are 100 kPa on the horizontal plane and 50 kPa on the vertical plane. Construction of a surface foundation induces additional stresses consisting of a vertical stress of 45 kPa, a lateral stress of 20 kPa, and a counterclockwise (with respect to the horizontal plane) shear stressof 40 kPa. Determine the change in orientation of the principal plane resulting from the construction of foundation. CHOICES ( WITH COMPLETE SOLUTION): a. principal stress plane rotates 23 degree counterclockwise from horizontal plane b. principal stress plane rotates 46 degree clockwise from horizontal plane c. principal stress plane rotates 23 degree clockwise from horizontal plane d. principal stress plane rotates 46 degree counterclockwise from horizontal plane

The plan of a foundation of uniform thickness for a building is shown in Figure 2. Determine the vertical stress increase at a depth of 10 m below the centroid. The foundation applies a vertical stress of 300 kPa on the soil surface.

please solve.