The relationship between atomic size and reducing strength in group 1A ( 1 ) and that between IE and oxidizing strength in group 7A ( 17 ) is to be established. Concept introduction: Atomic size is a measure of the size of the atoms It is the distance from the nucleus to the valence shell where the electrons are located. It increases down the group and decreases along the period. The ionization energy is the amount of energy required to remove the most loosely bound valence electrons from an isolated neutral gaseous atom. It is represented by IE. Its value decreases down the group and increases along the period. Oxidation occurs when there is a loss of electrons The element that loses its electrons itself gets oxidized and act as a reducing agent. Its strength is determined by the ease with which it loses the electron. Reduction happens when there is a gain of electrons. The element that gains electrons from the other species itself gets reduced and act as an oxidizing agent. Its strength can be measured by the ease with which it gains electrons.

Question

Want to see the full answer?

Answer 1

Question

Chapter 8, Problem 8.63P

Interpretation Introduction

Interpretation:

The relationship between atomic size and reducing strength in group 1A(1) and that between IE and oxidizing strength in group 7A(17) is to be established.

Concept introduction:

Atomic size is a measure of the size of the atoms It is the distance from the nucleus to the valence shell where the electrons are located. It increases down the group and decreases along the period.

The ionization energy is the amount of energy required to remove the most loosely bound valence electrons from an isolated neutral gaseous atom. It is represented by IE. Its value decreases down the group and increases along the period.

Oxidation occurs when there is a loss of electrons The element that loses its electrons itself gets oxidized and act as a reducing agent. Its strength is determined by the ease with which it loses the electron.

Reduction happens when there is a gain of electrons. The element that gains electrons from the other species itself gets reduced and act as an oxidizing agent. Its strength can be measured by the ease with which it gains electrons.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

9. OA. Rank the expected boiling points of the compounds shown below from highest to lowest. Place your answer appropriately in the box. Only the answer in the box will be graded. (3) points) OH OH بر بد بدید 2 3

There is an instrument in Johnson 334 that measures total-reflectance x-ray fluorescence (TXRF) to do elemental analysis (i.e., determine what elements are present in a sample). A researcher is preparing a to measure calcium content in a series of well water samples by TXRF with an internal standard of vanadium (atomic symbol: V). She has prepared a series of standard solutions to ensure a linear instrument response over the expected Ca concentration range of 40-80 ppm. The concentrations of Ca and V (ppm) and the instrument response (peak area, arbitrary units) are shown below. Also included is a sample spectrum. Equation 1 describes the response factor, K, relating the analyte signal (SA) and the standard signal (SIS) to their respective concentrations (CA and CIS). Ca, ppm V, ppm SCa, arb. units SV, arb. units 20.0 10.0 14375.11 14261.02 40.0 10.0 36182.15 17997.10 60.0 10.0 39275.74 12988.01 80.0 10.0 57530.75 14268.54 100.0…

A mixture of 0.568 M H₂O, 0.438 M Cl₂O, and 0.710 M HClO are enclosed in a vessel at 25 °C. H₂O(g) + C₁₂O(g) = 2 HOCl(g) K = 0.0900 at 25°C с Calculate the equilibrium concentrations of each gas at 25 °C. [H₂O]= [C₁₂O]= [HOCI]= M Σ M