
(a)
Interpretation:
Among four coins in which two are heads and two are tails and four coins in which one is head and three are tails, the one thathas higher entropy is to be stated. The reason for the answer is to be explained.
Concept introduction:
Entropy is defined as the randomness of molecules in a system. It is an extensive property. Entropy is directly proportional to natural logarithm to probability. It is represented as shown below.

Answer to Problem 8.18P
Four coins in which two are heads and two are tails has a higher entropy. The entropy for the first case
Explanation of Solution
Entropy is directly proportional to natural logarithm to probability. It is represented as shown below.
Where,
•
•
•
When four coins are flipped, there are six possible cases in which two are heads and two are tails which are shown below.
Similarly, when four coins are flipped, there are three possible cases in which one is head and three are tails which are shown below.
Substitute the above values in equation (1). Therefore, the entropy for the first case is calculated as shown below.
Similarly, the entropy for the second case is calculated as shown below.
Therefore, the first case has a higher entropy.
The entropy for the first case
(b)
Interpretation:
Among six coins in which two are heads and four are tails and six coins in which two are tails and four are heads, the one that has higher entropy is to be stated. The reason for the answer is to be explained.
Concept introduction:
Entropy is defined as the randomness of molecules in a system. It is an extensive property. Entropy is directly proportional to natural logarithm to probability. It is represented as shown below.

Answer to Problem 8.18P
The entropy for both the cases is same and has a value of
Explanation of Solution
Entropy is directly proportional to natural logarithm to probability. It is represented as shown below.
Where,
•
•
•
When six coins are flipped, there are
Similarly, when six coins are flipped, there are
Substituting the above values in equation (1). Therefore, the entropy for the first case is calculated as shown below.
Similarly, the entropy for the second case is calculated as shown below.
Therefore, entropy for both cases is equal.
The entropy for both the cases is same.
(c)
Interpretation:
Among
Concept introduction:
Entropy is defined as the randomness of molecules in a system. It is an extensive property. Entropy is directly proportional to natural logarithm to probability. It is represented as shown below.

Answer to Problem 8.18P
The number of moles is higher in the second case which means its entropy is also higher. Due to the directly proportional relation between the number of moles and entropy.
Explanation of Solution
Entropy and the number of moles are directly proportional to each other. If the number of moles increases on the product side. Then the entropy of the reaction increases. In the given cases, the number of moles is higher in the second case that is
Entropy and the number of moles are directly proportional to each other. The number of moles is higher in the second case which means its entropy is also higher.
Want to see more full solutions like this?
Chapter 8 Solutions
Organic Chemistry Study Guide and Solutions
- Calculate the cell potential for the following reaction that takes place in an electrochemical cell at 25°C. Mg(s) ∣ Mg2+(aq, 2.74 M) || Cu2+(aq, 0.0033 M) ∣ Cu(s)arrow_forwardCalculate E° for Ni(glycine)2 + 2e– D Ni + 2 glycine– given Ni2+ + 2 glycine– D Ni(glycine)2 K = 1.2×1011 Ni2+ + 2 e– D Ni E° = -0.236 Varrow_forwardOne method for the analysis of Fe3+, which is used with a variety of sample matrices, is to form the highly colored Fe3+–thioglycolic acid complex. The complex absorbs strongly at 535 nm. Standardizing the method is accomplished using external standards. A 10.00-ppm Fe3+ working standard is prepared by transferring a 10-mL aliquot of a 100.0 ppm stock solution of Fe3+ to a 100-mL volumetric flask and diluting to volume. Calibration standards of 1.00, 2.00, 3.00, 4.00, and 5.00 ppm are prepared by transferring appropriate amounts of the 10.0 ppm working solution into separate 50-mL volumetric flasks, each of which contains 5 mL of thioglycolic acid, 2 mL of 20% w/v ammonium citrate, and 5 mL of 0.22 M NH3. After diluting to volume and mixing, the absorbances of the external standards are measured against an appropriate blank. Samples are prepared for analysis by taking a portion known to contain approximately 0.1 g of Fe3+, dissolving it in a minimum amount of HNO3, and diluting to…arrow_forward
- Absorbance and transmittance are related by: A = -log(T) A solution has a transmittance of 35% in a 1-cm-pathlength cell at a certain wavelength. Calculate the transmittance if you dilute 25.0 mL of the solution to 50.0 mL? (A = εbc) What is the transmittance of the original solution if the pathlength is increased to 10 cm?arrow_forwardUnder what conditions will Beer’s Law most likely NO LONGER be linear? When the absorbing species is very dilute. When the absorbing species participates in a concentration-dependent equilibrium. When the solution being studied contains a mixture of ions.arrow_forwardCompared to incident (exciting) radiation, fluorescence emission will have a: Higher energy Higher frequency Longer wavelengtharrow_forward
- Lin and Brown described a quantitative method for methanol based on its effect on the visible spectrum of methylene blue. In the absence of methanol, methylene blue has two prominent absorption bands at 610 nm and 663 nm, which correspond to the monomer and the dimer, respectively. In the presence of methanol, the intensity of the dimer’s absorption band decreases, while that for the monomer increases. For concentrations of methanol between 0 and 30% v/v, the ratio of the two absorbance, A663/ A610, is a linear function of the amount of methanol. Use the following standardization data to determine the %v/v methanol in a sample if A610 is 0.75 and A663 is 1.07.arrow_forwardThe crystal field splitting energy, Δ, of a complex is determined to be 2.9 × 10-19 What wavelength of light would this complex absorb? What color of light is this? What color would the compound be in solution?arrow_forwardA key component of a monochromator is the exit slit. As the exit slit is narrowed, the bandwidth of light (i.e., the range of wavelengths) exiting the slit gets smaller, leading to higher resolution. What is a possible disadvantage of narrowing the exit slit? (Hint: why might a narrower slit lower the sensitivity of the measurement?).arrow_forward
- An x-ray has a frequency of 3.33 × 1018 What is the wavelength of this light?arrow_forwardChoose the Lewis structure for the compound below: H2CCHOCH2CH(CH3)2 HH H :d H H H C. Η H H HH H H H H. H H H HH H H H H H- H H H C-H H H HHHHarrow_forwardEach of the highlighted carbon atoms is connected to hydrogen atoms.arrow_forward
- Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningChemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningPrinciples of Modern ChemistryChemistryISBN:9781305079113Author:David W. Oxtoby, H. Pat Gillis, Laurie J. ButlerPublisher:Cengage Learning
- General Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage Learning





