The expectations should be determined when the TLC plate is allowed to remain the chamber of development for long time, so that the solvent reaches at the top of the plate during analysis of mixture. Concept introduction: TLC works on the principle of separation of constituents of a mixture of compounds based on polarity. The polar compounds interact with the stationary phase thus can move to smaller distance from the base. While the non polar compounds tend to move faster as they interact less with the silica gel; therefore, they move far from the base of the plate.

Question

Predicting edict the major products of this organic reaction. If there aren't any products, because nothing will happen, check the box under the drawing area instead. + No reaction. Explanation Check HO Na O H xs H₂O 2 Click and drag to start drawing a structure. © 2025 McGraw Hill LLC. All Rights Reserved. Terms of Use | Privacy Center I

Answer 1

Question

Chapter 8, Problem 5Q

Interpretation Introduction

Interpretation:

The expectations should be determined when the TLC plate is allowed to remain the chamber of development for long time, so that the solvent reaches at the top of the plate during analysis of mixture.

Concept introduction:

TLC works on the principle of separation of constituents of a mixture of compounds based on polarity. The polar compounds interact with the stationary phase thus can move to smaller distance from the base. While the non polar compounds tend to move faster as they interact less with the silica gel; therefore, they move far from the base of the plate.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

Predicting edict the major products of this organic reaction. If there aren't any products, because nothing will happen, check the box under the drawing area instead. + No reaction. Explanation Check HO Na O H xs H₂O 2 Click and drag to start drawing a structure. © 2025 McGraw Hill LLC. All Rights Reserved. Terms of Use | Privacy Center I

Choosing reagents and conditions for acetal formation or hydrolysis 0/5 A student proposes the transformation below in one step of an organic synthesis. There may be one or more products missing from the right-hand side, but there are no reagents missing from the left-hand side. There may also be catalysts, small inorganic reagents, and other important reaction conditions missing from the arrow. • Is the student's transformation possible? If not, check the box under the drawing area. If the student's transformation is possible, then complete the reaction by adding any missing products to the right-hand side, and adding required catalysts, inorganic reagents, or other important reaction conditions above and below the arrow. • You do not need to balance the reaction, but be sure every important organic reactant or product is shown. + This transformation can't be done in one step. 5 I H Autumn alo 值 Ar B

A block of copper of mass 2.00kg(cp = 0.3851 .K) and g temperature 0°C is introduced into an insulated container in which there is 1.00molH, O(g) at 100°C and 1.00 2 atm. Note that C P = 4.184. K for liquid water, and g that A H = 2260 for water. vap g Assuming all the steam is condensed to water, and that the pressure remains constant: (a) What will be the final temperature of the system? (b) What is the heat transferred from the water to the copper? (c) What is the entropy change of the water, the copper, and the total system?