The reason for diethyl ether to be a good extraction solvent than acetone needs to be explained. Concept Introduction: Solvent extraction method is also called as liquid-liquid extraction. It is the method that is used to separate compounds on the basis of their relative solubility in two different immiscible solvents. Here the immiscible solvents cannot get mixed up together.Therefore,they make two separate layers. In the extraction of a solute from one liquid, another immiscible solvent must be used. Usually water is used with certain organic solvent as organic solvent and water are immiscible into each other.At equilibrium, the solute concentration ratio is constant in each layer which is represented by partition or distribution coefficient. At equilibrium, it is the ratio of the concentration of a substance in one medium (C 1 ) to the concentration in a second medium (C 2 ) at equilibrium. K d = C 1 C 2

Question

Want to see the full answer?

Answer 1

Question

Chapter 5.4, Problem 1E

Interpretation Introduction

Interpretation:The reason for diethyl ether to be a good extraction solvent than acetone needs to be explained.

Concept Introduction:

Solvent extraction method is also called as liquid-liquid extraction. It is the method that is used to separate compounds on the basis of their relative solubility in two different immiscible solvents.

Here the immiscible solvents cannot get mixed up together.Therefore,they make two separate layers. In the extraction of a solute from one liquid, another immiscible solvent must be used. Usually water is used with certain organic solvent as organic solvent and water are immiscible into each other.At equilibrium, the solute concentration ratio is constant in each layer which is represented by partition or distribution coefficient. At equilibrium, it is the ratio of the concentration of a substance in one medium (C₁) to the concentration in a second medium (C₂) at equilibrium.

Kd = C1C2

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

(a 4 shows scanning electron microscope (SEM) images of extruded actions of packing bed for two capillary columns of different diameters, al 750 (bottom image) and b) 30-μm-i.d. Both columns are packed with the same stationary phase, spherical particles with 1-um diameter. A) When the columns were prepared, the figure shows that the column with the larger diameter has more packing irregularities. Explain this observation. B) Predict what affect this should have on band broadening and discuss your prediction using the van Deemter terms. C) Does this figure support your explanations in application question 33? Explain why or why not and make any changes in your answers in light of this figure. Figure 4 SEM images of sections of packed columns for a) 750 and b) 30-um-i.d. capillary columns.³

fcrip = ↓ bandwidth Il temp 32. What impact (increase, decrease, or no change) does each of the following conditions have on the individual components of the van Deemter equation and consequently, band broadening? Increase temperature Longer column Using a gas mobile phase instead of liquid Smaller particle stationary phase Multiple Paths Diffusion Mass Transfer

34. Figure 3 shows Van Deemter plots for a solute molecule using different column inner diameters (i.d.). A) Predict whether decreasing the column inner diameters increase or decrease bandwidth. B) Predict which van Deemter equation coefficient (A, B, or C) has the greatest effect on increasing or decreasing bandwidth as a function of i.d. and justify your answer. Figure 3 Van Deemter plots for hydroquinone using different column inner diameters (i.d. in μm). The data was obtained from liquid chromatography experiments using fused-silica capillary columns packed with 1.0-μm particles. 35 20 H(um) 큰 20 15 90 0+ 1500 100 75 550 01 02 594 05 μ(cm/sec) 30 15 10