bartleby

Concept explainers

Question
Book Icon
Chapter 5.4, Problem 1BYG
To determine

Explain the term ethics.

Expert Solution & Answer
Check Mark

Explanation of Solution

The word Ethics refers set of moral principle or standards that one should follow in his profession for the good and safety of the society. It is a set of standard rules and regulation that governs one’s behavior while involving in an activity. These Rules are usually made by a group of people called the board of directors depending on the safety of people, welfare and development of the society, maintaining the moral of the profession they take care.

Conclusion:

Thus, the term ethic has been explained.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
Students have asked these similar questions
Locate imaginary wells on Figure P7.5.1, which will replace the actual boundaries with an equivalent hydraulic system. Stream a Real well Impermeable boundary
You are an engineer designing an aeration tank for a wastewater treatment plant receiving municipal waste. The activated sludge system (aeration tank and secondary clarifier) you design needs to remove 85% of the incoming BODs from the primary effluent, giving a final concentration of 30.0 mg BODs/L exiting the system. Your design will maintain a concentration of 2500 mg VSS/L and F/M ratio of 0.5 g BOD/g VSS d in the aeration tank. In an effort to keep the waste activated sludge low in water, only about 0.1% of the primary effluent flow (Q) exits the WAS line. The secondary effluent has a flow rate of 9990 m³/d. What volume (in m³) will the aeration tank need to be? Write out all equations and state any assumptions as needed. Primary effluent: Q. Xo, So Aeration tank V, X, S Secondary Secondary clarifier effluent: Qe, X, S O RAS line: Q, X., S Activated sludge control volume WAS line: Qwx, S
b) Workers in a 1000 m³ processing room in a plastics factory are exposed to vinyl chloride (C2H3CI) gas, which is emitted when the plastic pellets are heated to make the final products. a) If the air change rate in the room is 0.21/h and the source strength of C2H3Cl is 68 mg/h, what is the steady state concentration of C2H3Cl (in mg/m³ and in ppmv) in the room at 25°C and 1 atm? Assume that C2H3Cl is conservative and that the concentration of the gas in the ambient air is zero. What is the concentration of vinyl chloride gas (in ppmv) in the same room 6 hours after all the machines are turned off at the end of the day?

Chapter 5 Solutions

WebAssign Homework Only for Moaveni's Engineering Fundamentals: An Introduction to Engineering, SI Edition, 6th Edition, [Instant Access]

Knowledge Booster
Background pattern image
Civil Engineering
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Engineering Fundamentals: An Introduction to Engi...
Civil Engineering
ISBN:9781305084766
Author:Saeed Moaveni
Publisher:Cengage Learning
Text book image
Fundamentals Of Construction Estimating
Civil Engineering
ISBN:9781337399395
Author:Pratt, David J.
Publisher:Cengage,