Mobile Service Provider Program Plan: Include the required header files. Define the “main()” function. Declare and define the required variables. Display the menu option which shows the list of available packages on the output screen. Get the choice from the user. Get minutes used by the user. Set the corresponding base rate value based upon the user choice. Find whether any additional minutes have been taken. Calculate the additional charge and finally calculate the total amount. Display the total cost on the output screen.

Question

Want to see the full answer?

Answer 1

Question

Chapter 4, Problem 25PC

Program Plan Intro

Mobile Service Provider

Program Plan:

Include the required header files.

Define the “main()” function.

Declare and define the required variables.

Display the menu option which shows the list of available packages on the output screen.

Get the choice from the user.

Get minutes used by the user.

Set the corresponding base rate value based upon the user choice.

Find whether any additional minutes have been taken.

Calculate the additional charge and finally calculate the total amount.

Display the total cost on the output screen.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

15 points Save ARS Consider the following scenario in which host 10.0.0.1 is communicating with an external SMTP mail server at IP address 128.119.40.186. NAT translation table WAN side addr LAN side addr (c), 5051 (d), 3031 S: (e),5051 SMTP B D (f.(g) 10.0.0.4 server 138.76.29.7 128.119.40.186 (a) is the source IP address at A, and its value. S: (a),3031 D: (b), 25 10.0.0.1 A 10.0.0.2. 1. 138.76.29.7 10.0.0.3

6.3A-3. Multiple Access protocols (3). Consider the figure below, which shows the arrival of 6 messages for transmission at different multiple access wireless nodes at times t=0.1, 1.4, 1.8, 3.2, 3.3, 4.1. Each transmission requires exactly one time unit. 1 t=0.0 2 3 45 t=1.0 t-2.0 t-3.0 6 t=4.0 t-5.0 For the CSMA protocol (without collision detection), indicate which packets are successfully transmitted. You should assume that it takes .2 time units for a signal to propagate from one node to each of the other nodes. You can assume that if a packet experiences a collision or senses the channel busy, then that node will not attempt a retransmission of that packet until sometime after t=5. Hint: consider propagation times carefully here. (Note: You can find more examples of problems similar to this here B.] ☐ U ப 5 - 3 1 4 6 2

Just wanted to know, if you had a scene graph, how do you get multiple components from a specific scene node within a scene graph? Like if I wanted to get a component from wheel from the scene graph, does that require traversing still? Like if a physics component requires a transform component and these two component are part of the same scene node. How does the physics component knows how to get the scene object's transform it is attached to, this being in a scene graph?