Concept explainers
(a)
To show: The point where
(a)
Answer to Problem 38.72AP
Explanation of Solution
Given info: The equation of the intensity of the light in the diffraction pattern is
The formula to calculate the intensity of the light is,
Here,
The value of
Substitute
Conclusion
Therefore, the point where
(b)
To draw: Plot
(b)
Answer to Problem 38.72AP
The graph between
Figure (1)
Explanation of Solution
Given info: The equation of the intensity of the light in the diffraction pattern is
The equation of
The solution of both the equation to coincide at a point is ,
So the solution of the transcendental equation is
(c)
To show: The angular full width at half maximum of the central diffraction maximum is
(c)
Answer to Problem 38.72AP
Explanation of Solution
Given info: The equation of the intensity of the light in the diffraction pattern is
The formula to calculate the phase angle is,
Rewrite the above equation for
If the value of
The path covered by the light is symmetric so the phase angle is double the initial value.
Substitute
Conclusion
Therefore, the angular full width at half maximum of the central diffraction maximum is
(d)
The number of steps involved to solve the transcendental equation ϕ = 2 sin ϕ
.
(d)
Answer to Problem 38.72AP
Explanation of Solution
Given info: The equation of the intensity of the light in the diffraction pattern is
The equation of
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The solution of the transcendental equation
Conclusion
Therefore, the number of steps involved to solve the transcendental equation
Want to see more full solutions like this?
Chapter 38 Solutions
EBK PHYSICS FOR SCIENTISTS AND ENGINEER
- i did this probelm and got an answer of 1.04 but the correct answer is 1.08. what did i do wrong?arrow_forward) Consider a crystal consisting of m + 1 lattice planes of spacing d, of total thickness t = md, being set for diffraction as depicted in Fig. 2. At the incidence angle ӨB, Braggs law is satisfied. Explain the phenomenon through which the angles Ө1 and Ө2 are the limiting angles at which the diffracted intensity falls to zero.arrow_forwarda beam of white light is shined at normal incidence onto the outside of a soap bubble (index of soap solution = 1.340). An observer looking at the bubble, opposite to the direction of the beam, notices that green light (Lambda = 555.0 nm) is particularly bright in the reflected spectrum. What is the second thinnest wall thickness of the bubble?arrow_forward
- First-order Bragg scattering from a certain crystal occurs at an angle of incidence of 63.8°; see figure below. The wavelength of the x-rays is 0.261nm. Assuming that the scattering is from the dashed planes shown, find the unit cell size ao. 63.8° X raysarrow_forwardQ/4 : In Biprism experiment the fringe width is 0.30 mm. If slits are covered by glass plate of thickness 0.04 mm and refractive index u = 1.5, then the fringe width is (a) 0.02 mm (b) 0.1 mm (c) 0.30 mm (d) 0.2 mmarrow_forwardThere is a circular slit with its radius a = 0.1mm. The distance between the slit plane and detector plane is given by R=1m. Roughly estimate the requirement of the wavelength of incident light for Fraunhofer diffraction with appropriate justification.arrow_forward
- Your physics study partner tells you that the width of the central bright band in a single-slit diffraction pattern is inversely proportional to the width of the slit. This means that the width of the central maximum increases when the width of the slit decreases. The claim seems counterintuitive to you, so you make measurements to test it. You shine monochromatic laser light with wavelength λ onto a very narrow slit of width a and measure the width w of the central maximum in the diffraction pattern that is produced on a screen 1.50 m from the slit. (By “width,” you mean the distance on the screen between the two minima on either side of the central maximum.) Your measurements are given in the table. (a) If w is inversely proportional to a, then the product aw is constant, independent of a. For the data in the table, graph aw versus a. Explain why aw is not constant for smaller values of a. (b) Use your graph in part (a) to calculate the wavelength λ of the laser light. (c) What is…arrow_forwardanswer in radianarrow_forwardlet a beam of x rays of wavelength 0.125 nm be incident on an NaCl crystal at angle u 45.0° to the top face of the crystal and a family of reflecting planes. Let the reflecting planes have separation d = 0.252 nm. The crystal is turned through angle f around an axis perpendicular to the plane of the page until these reflecting planes give diffraction maxima. What are the (a) smaller and (b) larger value of f if the crystal is turned clockwise and the (c) smaller and (d) larger value of f if it is turned counterclockwise?arrow_forward
- Problem 1: In a double slit experiment the first minimum for 415 nm violet light is at an angle of 42°. Randomized Variables 2 = 415 nm e = 42 ° Find the distance between the two slits in micrometers. d= 8 9 5 6 sin() cos() tan() 7 HOME cotan() asin() acos() E A 4 atan() acotan() sinh() 1 2 3 cosh() tanh() cotanh() END O Degrees O Radians Vol BACKSPACE DEL CLEAR +arrow_forward632.8 nm) is used to calibrate a diffraction grating. If the first-order maximum occurs at 21.0°, what is the spacing between adjacent grooves in the grating? (In this problem, assume that the light is incident normally on the grating.) μm A helium-neon laser (1 =arrow_forwardA telescope can be used to enlarge the diameter of a laser beam and limit diffraction spreading. The laser beam is sent through the telescope in opposite the normal direction and can then be projected onto a satellite or the Moon. If this is done with the Mount Wilson telescope, producing a 2.54 m diameter beam of 613 nm light, what is the minimum angular spread of the beam? Neglecting atmospheric effects, what is the size of the spot this beam would make on the Moon, assuming a lunar distance of 3.84×108 m?arrow_forward
- University Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStax