Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 34, Problem 1ASRQ
While discussing the proper way to test a catalytic converter: Technician A says that a pressure gauge can be inserted into the oxygen sensor bore and the backpressure caused by the converter measured. Technician B says that restrictions in the converter can be checked with a vacuum gauge while the engine is being quickly accelerated. Who is correct?
a. Technician A only
b. Technician B only
c. Both A and B
d. Neither A nor B
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
While discussing EFI systems: Technician A says that the PCM provides the proper air-fuel ratio by controlling the fuel pressure. Technician B says that the PCM provides the proper air-fuel ratio by controlling injector pulse width. Who is correct? *
1 point
a. Technician A
b. Technician B
c. Both A and B
d. Neither A nor B
I need the answer as soon as possible
An engine starts and runs briefly after a small quantity of fuel is put into the spark plug hole, but it doesn't not start when fuel is added to the carburetor throat. Tech a says that the problem may be that the exhaust valve is not closing completely due to carbon buildup. Tech b says it may be due to a defective carburetor mounting gasket. Who is correct?
Chapter 34 Solutions
Automotive Technology
Ch. 34 - A rich air-fuel ratio causes HC emissions to...Ch. 34 - What will result from too little EGR flow? And...Ch. 34 - What can result from a charcoal canister that is...Ch. 34 - What happens if a PCV valve is stuck in the open...Ch. 34 - Explain why the I/M 240 and similar tests are...Ch. 34 - How do you test the efficiency of a secondary AIR...Ch. 34 - List five common causes for high HC emissions.Ch. 34 - Describe carbon monoxide (CO) emissions in...Ch. 34 - An EGR valve that does not fully close can cause...Ch. 34 - A restricted catalytic converter can cause all of...
Ch. 34 - Which of the following statements about EVAP...Ch. 34 - As a catalytic converter begins to deteriorate,...Ch. 34 - How much pressure does a typical EVAP pressure...Ch. 34 - Which of the following exhaust gases is typically...Ch. 34 - Prob. 7MCCh. 34 - While discussing the proper way to test a...Ch. 34 - Prob. 2ASRQCh. 34 - While discussing catalytic converter diagnosis:...Ch. 34 - While discussing EGR valve diagnosis: Technician A...Ch. 34 - While discussing EGR valve diagnosis: Technician A...Ch. 34 - When discussing the diagnosis of a positive back...Ch. 34 - While diagnosing a PCV problem: Technician A says...Ch. 34 - Technician A says that the AIR system should pump...Ch. 34 - While discussing PCV system diagnosis: Technician...Ch. 34 - While discussing EVAP testing: Technician A says...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Technician A says that you may be able to smell antifreeze from a leaking heater core. Technician B says that you may be able to hear a loose belt when the engine is running. Who is correct? Select one: a. Technician A only b. Technician B only c. Both A and B d. Neither A nor Barrow_forwardA vehicle has had several radiator replacements, and each time there has been pinhole leaks in the aluminum. Technician A states that the engine coolant may need to be exchanged more often. Technician B states that the engine grounds should be inspected closely since this could be the cause. Who is correct? Select one: a. Technician A only b. Technician B only c. Both Technicians A and B d. Neither Technician A nor Barrow_forwardWhen performing an engine oil level check, if additional oil is needed, estimate the amount by checking the emissions standards guide to the dipstick markings. Select one: True Falsearrow_forward
- an engine is being discussed for lean running condition. technician A checks for air leak in the intake. Technician B checks for alcohol in the fuel. who is correct?arrow_forwardWhile discussing the MIL on OBD II systems: Technician A says that the MIL will flash if the PCM detects a fault that would damage the catalytic converter. Technician B says that whenever the PCM has detected a fault, it will turn on the MIL. Who is correct? a. Technician A • Technician B • Both A and B • Neither A nor Barrow_forwardTechnician A says that if the oil pressure shows low on the vehicle's gauge, engine oil pressure should be verified using a manual test gauge. Technician B says that if a vehicle's oil pressure gauge reads too high, engine oil pressure should be verified using a manual test gauge. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forward
- While discussing returnless fuel systems: Technician A says that in a returnless fuel system the pressure regulator is mounted on the fuel rail. Technician B says that in this type of fuel system the pump and pressure regulator are combined in one unit. Who is correct? A.Technician A B.Technician B C.Both A and B D.Neither A nor Barrow_forwardTechnician A says that black exhaust smoke is an indication of a too-rich air-fuel mixture. Technician B says that white smoke (steam) is an indication of coolant being burned in the engine.arrow_forwardTechnician A says that when draining the engine oil, the engine should be fully cold for best results. Technician B says that the engine should be running when checking the engine oil level. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forward
- Which of the following statements about carbondioxide is not true?a. CO2 levels are highest when the air-fuel ratiois slightly leaner than stoichiometric.b. The production of CO2 is directly related tothe amount of fuel consumed; therefore,more fuel-efficient engines produce less CO2c. To reduce CO2 levels in the exhaust, engineers are working hard to decrease fuel consumption to keep CO2low.d. The concern for CO2 emissions is one of theprimary reasons for the delayed use of alternative fuels for automobiles.arrow_forwardTechnician A says that an EGR valve that is stuck open can cause idle problems. Technician B says that a stuck closed EGR can increase HC emissions. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor Barrow_forwardWhat is meant by sequential firing of fuel injectors?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
The Refrigeration Cycle Explained - The Four Major Components; Author: HVAC Know It All;https://www.youtube.com/watch?v=zfciSvOZDUY;License: Standard YouTube License, CC-BY