AUTOMOTIVE TECHNOLOGY -W/MINDTAP ACCESS
7th Edition
ISBN: 9780357096789
Author: ERJAVEC
Publisher: CENGAGE L
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 32, Problem 7ASRQ
Before replacing any exhaust system component: Technician A soaks all old connections with penetrating oil. Technician B checks the old systems routing for critical clearance points. Who is correct?
a. Technician A
b. Technician B
c. Both A and B
d. Neither A nor B
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Technician A says that you may be able to
smell antifreeze from a leaking heater core.
Technician B says that you may be able to
hear a loose belt when the engine is running.
Who is correct?
Select one:
a. Technician A only
b. Technician B only
c. Both A and B
d. Neither A nor B
Technician A says that the engine oil drain
plug typically needs to be replaced with a
new one at each oil change. Technician B
says that engine oil drain plugs must be
tightened with a torque wrench when they
are installed. Who is correct?
Select one:
a. Technician A
b. Technician B
c. Both A and B
d. Neither A nor B
d. Check oil level & moisture content
19. If the main wire (coil) to the distributor and the coil to the switch are broken, replace them and make
sure the connections are clean and tight relevant to
a. Breaking system
b. Ignition system
c. Ventilation system
d. Combustion system
20. The required gap in ignition system between----------
a.-4 to 5
b.-0.4 to 5
c.-0.4 to 0.5
d.-4 to 0,5
|21. Which of the following is the fouled of spark plug
a. Soot
b. Oil
c. Over heated
d. All of the above
|22.The suitable thread of spark plug for heavy engine is
a. M19
b. M18
c. M15
d. M16
23. Using a Torque wrench, tighten the plugs to the specified torque. (Most) 4mm plugs are torqued to
four kilograms per square inch.
a. True
b. False
24. Start the engine and evaluate its performance refers to
a. Weekly Maintenance
b. Annually Maintenance
c. Daily Maintenance
d. None of them
25. Check to see if Dynamo is working properly. If necessary, adjust the regulator refers to
a. Weekly Maintenance
b. Annually…
Chapter 32 Solutions
AUTOMOTIVE TECHNOLOGY -W/MINDTAP ACCESS
Ch. 32 - What is the difference between psia and psig...Ch. 32 - Describe two methods to check for a restricted...Ch. 32 - What is acoustic supercharging?Ch. 32 - Describe the basic operation of an intake manifold...Ch. 32 - Prob. 5SACh. 32 - Prob. 6SACh. 32 - True or False? All wastegates are controlled by...Ch. 32 - True or False? Engine misfires can cause a...Ch. 32 - A mini-converter is used _____. a. on small...Ch. 32 - A restricted exhaust system can cause______. a....
Ch. 32 - Which of the following is not characteristic of a...Ch. 32 - Ten psi of turbo boost means that air is being fed...Ch. 32 - What manages turbo output by controlling the...Ch. 32 - What is the first step in turbocharger inspection?...Ch. 32 - Prob. 7MCCh. 32 - Technician A says that a turbocharger has its own...Ch. 32 - Technician A makes sure that the exhaust system is...Ch. 32 - Technician A says vacuum refers to any pressure...Ch. 32 - Technician A uses sandpaper to remove carbon...Ch. 32 - Technician A says that a vacuum leak results in...Ch. 32 - Technician A says that vacuum hose routing for the...Ch. 32 - Before replacing any exhaust system component:...Ch. 32 - A vehicles intake manifold is warped: Technician A...Ch. 32 - Technician A says that the catalytic converter is...Ch. 32 - Technician A says that the exhaust manifold gasket...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- A vehicle has had several radiator replacements, and each time there has been pinhole leaks in the aluminum. Technician A states that the engine coolant may need to be exchanged more often. Technician B states that the engine grounds should be inspected closely since this could be the cause. Who is correct? Select one: a. Technician A only b. Technician B only c. Both Technicians A and B d. Neither Technician A nor Barrow_forwardA technician is inspecting a vehicle and finds the upper radiator hose is collapsed, and the cooling system pulled into a vacuum when cold. Technician A states that a leak in the surge tank could be the cause. Technician B states that the radiator cap is most likely defective. Who is correct? Select one: a. Technician A only b. Technician B only c. Both Technicians A and B d. Neither Technician A nor Barrow_forwardPressure regulators are being discussed. Technician A says they are located in the fuel rail. Technician B says they are located on the fuel rail. Who is correct? a. A only b. B only c. Both A and B d. Neither A nor Barrow_forward
- Technician A says that an air-conditioning system removes heat from inside the engine. Technician B says that the heating system removes heat from the inside of the vehicle. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardTechnician A says that when installing an oil filter, you should tighten it with a filter wrench to prevent it from falling off. Technician B says that oil filters should only be installed by hand. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardTechnician A says that black exhaust smoke is an indication of a too-rich air-fuel mixture. Technician B says that white smoke (steam) is an indication of coolant being burned in the engine.arrow_forward
- Technician A says that liquid cooling an engine helps to maintain a consistent operating temperature. Technician B says that oil is circulated through the cooling system to remove heat from the engine's parts. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardWhat part of a relief valve covers the exhaust port? A. Cap B. Ball C. Spring D. Diaphragmarrow_forwardI need the answer as soon as possiblearrow_forward
- While discussing central port injection systems: Technician A says that CPI systems use one injector and several injector nozzles. Technician B says that CPI systems open each injector sequentially. Who is correct? A.Technician A B.Technician B C.Both A and B D.Neither A nor Barrow_forwardTechnician A says that when using a flare-nut wrench, two wrenches must often be used. Technician B says to use an open-end wrench on fuel fittings. Who is right?arrow_forwardTechnician A says that coolant hoses should be squeezed to check for hardening or softening. Technician B says that coolant hoses should be visually inspected for swelling and cracks. Who is correct? Select one: a. Technician A only b. Technician B only c. Both A and B d. Neither A nor Barrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Automotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Welding: Principles and Applications (MindTap Cou...Mechanical EngineeringISBN:9781305494695Author:Larry JeffusPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Welding: Principles and Applications (MindTap Cou...
Mechanical Engineering
ISBN:9781305494695
Author:Larry Jeffus
Publisher:Cengage Learning
The Refrigeration Cycle Explained - The Four Major Components; Author: HVAC Know It All;https://www.youtube.com/watch?v=zfciSvOZDUY;License: Standard YouTube License, CC-BY