Automotive Technology: A Systems Approach (MindTap Course List)
6th Edition
ISBN: 9781133612315
Author: Jack Erjavec, Rob Thompson
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 31, Problem 6RQ
Which of the following is a likely cause of a lean condition during acceleration and cruising speeds?
a. A defective oxygen sensor
b. A defective PCM
c. A defective ECT sensor
d. A defective MAF sensor
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Which of the following is not a voltage-generating type sensor?
vehicle speed sensor
OSS
MAP
ISS
Describe the two basic types of passenger weightdetection sensors used in most vehicles
A vehicle with a direct TPMS is brought into a shop with all sensors failing to read any pressure at all. Technician A says it’s likely that all 4 sensors died at once. Technician B says it may be due to a damaged or faulty TPMS antenna. Who is correct?
Technician A
Technician B
Both Technician A and B
Neither Technician A or B
Chapter 31 Solutions
Automotive Technology: A Systems Approach (MindTap Course List)
Ch. 31 - List four service precautions for working on the...Ch. 31 - What is indicated by a LTFT reading of 24 percent?Ch. 31 - What is the correct procedure for checking an...Ch. 31 - What is the difference between STFT and LTFT?Ch. 31 - The PCM checks for a closed throttle plate each...Ch. 31 - Which of the following is a likely cause of a lean...Ch. 31 - What problem may result from dirt buildup on an...Ch. 31 - Which of the following would not cause a...Ch. 31 - What is the correct way to test an injector with...Ch. 31 - What is the difference between the pulse width and...
Ch. 31 - How can you use a dual trace scope to make sure...Ch. 31 - What are three possible problems that can allow...Ch. 31 - What is the purpose of having two accelerator...Ch. 31 - What is indicated by a negative LTFT value?Ch. 31 - True or False? The signals from an air-fuel ratio...Ch. 31 - While discussing the causes of...Ch. 31 - While discussing IAC valve diagnosis: Technician A...Ch. 31 - While discussing IAC motor removal, service, and...Ch. 31 - While discussing injector testing: Technician A...Ch. 31 - While discussing airflow sensors: Technician A...Ch. 31 - While discussing scan tool diagnosis of fuel...Ch. 31 - While discussing a high idle speed problem:...Ch. 31 - While discussing the causes of a rich air-fuel...Ch. 31 - While diagnosing an idle speed problem: Technician...Ch. 31 - While looking at fuel trim values: Technician A...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- True or False? An A/F ratio sensor can be tested in the same way as an oxygen sensor.arrow_forwardA defective LAT sensor or circuit may cause the fol lowing problems, except. hard engine starting rich or lean air-fuel ratio improper converter clutch lockup reduced fuel economyarrow_forwardA digital speedometer constantly reads 0 mph: Technician A says that the problem may be the vehicle speed sensor. Technician B says that the problem may be the throttle position sensor. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- 104) Which of the following inputs is NOT a driver commanded input? Brake pedal switch Mass airflow sensor Throttle position sensor Transmission range sensorarrow_forwardWhile diagnosing a cruise control system that does not turn on: Technician A checks the vehicle speed sensor and its input to the control module. Technician B checks the operation of the brake lights. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhich of the following would not cause noise while driving in 2WD under a heavy throttle? a. Faulty ignition switch b. Worn transfer case clutch c. Inoperative locking hubs d. Bad front half shaftarrow_forward
- True or False? On some engines, if the gap between the crankshaft sensor and its trigger wheel is outside specifications, the sensor should be replaced.arrow_forwardWhen diagnosing a vacuum/mechanical cruise control system that cannot maintain a constant speed, all of the following should be checked, except. the brake switch the vacuum lines the vacuum servo the vehicle speed sensorarrow_forwardTechnician A says that many oil pressure sensors are typically variable resistors that change resistance based on pressure changes. Technician B says that a sensor substitution box can be used in place of the sensor while observing the reaction of the oil pressure gauge on the dash. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forward
- A TPMS sensor re-learn procedure is being discussed. Technician A says you must always use a scan tool to initiate the re-learn process. Technician B says letting air out of the tires will initiate the re-learn procedure. Who is correct? Technician A Technician B Both Technician A and B Neither Technician A or Barrow_forwardA vehicle with a direct TPMS just had all 4 tires replaced, yet the TPMS warning light is on. Technician A says this may be due to the tire tech damaging one of the sensors during tire replacement. Technician B says it may be caused by the tire tech damaging the wheel speed sensor during tire install. Who is correct? Technician A Technician B Both Technician A and B Neither Technician A or Barrow_forwardBecause modern engines heat up rapidly heated oxygen sensor (ho2s) are not required. True Falsearrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Automotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Mod-01 Lec-16 Basics of Instrumentation; Author: nptelhrd;https://www.youtube.com/watch?v=qbKnW42ZM5c;License: Standard YouTube License, CC-BY