Thermogravimetric curve is to be determined from the given mass and melting point. Concept introduction: Thermogravimetric curve is a plot ofthe percentage of mass and temperature, comprising of a progression of a numbers of steps, acquired by estimating the mass of a sample during heating. It is a strategy used for heat calculation where the mass of a sample is estimated after some time as the temperature changes.

Question

In the initial linear section of the stress-strain curve of a metal or alloy. Explain from the point of view of atomic structure?(a) No, the atomic level properties of the material can never be related to the linear section.(b) The elastic zone is influenced by the strength of the bonds between atoms.(c) The stronger the bond, the less rigid and the lower the Young's Modulus of the material tested.(d) The stronger the bond, the less stress is necessary to apply to the material to deform it elastically.

Answer 1

Question

Chapter 31, Problem 31.3QAP

Interpretation Introduction

Interpretation:

Thermogravimetric curve is to be determined from the given mass and melting point.

Concept introduction:

Thermogravimetric curve is a plot ofthe percentage of mass and temperature, comprising of a progression of a numbers of steps, acquired by estimating the mass of a sample during heating. It is a strategy used for heat calculation where the mass of a sample is estimated after some time as the temperature changes.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

In the initial linear section of the stress-strain curve of a metal or alloy. Explain from the point of view of atomic structure?(a) No, the atomic level properties of the material can never be related to the linear section.(b) The elastic zone is influenced by the strength of the bonds between atoms.(c) The stronger the bond, the less rigid and the lower the Young's Modulus of the material tested.(d) The stronger the bond, the less stress is necessary to apply to the material to deform it elastically.

The degree of polymerization of polytetrafluoroethylene (Teflon) is 7500 (mers/mol). If all polymer chains have equal length, state the molecular weight of the polymer and the total number of chains in 1000 g of the polymer(a) 50 000 g/mol; 0.03·1020 chains(b) 100 000 g/mol; 1.03·1020 chains(c) 750 000 g/mol; 8.03·1020 chains

In natural rubber or polyisoprene, the trans isomer leads to a higher degree of crystallinity and density than the cis isomer of the same polymer, because(a) it is more symmetrical and regular.(b) it is less symmetrical.(c) it is irregular.