Amino acid with the lowest pI value needs to be identified from the given set of amino acids. Concept introduction: Amino acids at a particular pH do not migrate in an electric field. This pH is known as the isoelectric point. The isoelectric point is also known as isotonic point. At this isoelectric point the amino acid is neutral. This means that the zwitterion form predominates more over the other forms. pI is the isoelectric point and this can be given by average of the pK a . pI= pK a 1 +pK a 2 2 The amino acid which has more acidic groups is said to have lower pI value and the compound which has more basic groups is said to have higher pI value. To find : the amino acid possessing the lowest pI from the given set of amino acid

Question

Want to see the full answer?

Answer 1

Question

Chapter 25.2, Problem 8CC

(a)

Interpretation Introduction

Interpretation:

Amino acid with the lowest pI value needs to be identified from the given set of amino acids.

Concept introduction:

Amino acids at a particular pH do not migrate in an electric field. This pH is known as the isoelectric point. The isoelectric point is also known as isotonic point. At this isoelectric point the amino acid is neutral. This means that the zwitterion form predominates more over the other forms. pI is the isoelectric point and this can be given by average of the pK_a.

pI=pKa1+pKa22

The amino acid which has more acidic groups is said to have lower pI value and the compound which has more basic groups is said to have higher pI value.

To find: the amino acid possessing the lowest pI from the given set of amino acid

(b)

Interpretation Introduction

Interpretation:

Amino acid with the lowest pI value needs to be identified from the given set of amino acids.

Concept introduction:

Amino acids at a particular pH do not migrate in an electric field. This pH is known as the isoelectric point. The isoelectric point is also known as isotonic point. At this isoelectric point the amino acid is neutral. This means that the zwitterion form predominates more over the other forms. pI is the isoelectric point and this can be given by average of the pK_a.

pI=pKa1+pKa22

The amino acid which has more acidic groups is said to have lower pI value and the compound which has more basic groups is said to have higher pI value.

To find: the amino acid possessing the lowest pI from the given set of amino acid

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

In an effort to reduce costs and increase the accessibility of instruments that utilize spectrophotometric detection, some researchers are beginning to experiment with 3D-printed parts. One example of this is the 3D-printed flow cell, shown at right. This device was made using polylactic acid and accommodates a LED at one end and a detector at the other. It can be used for standalone flow injection spectrophotometry or coupled to a chromatographic separation to be used as a detector. Explain why the sensitivity varies with the length of the flow cell, as shown in the data below. Could this setup be used for fluorescence analysis? Why or why not?

The dark lines in the solar spectrum were discovered by Wollaston and cataloged by Fraunhofer in the early days of the 19th century. Some years later, Kirchhoff explained the appearance of the dark lines: the sun was acting as a continuum light source and metals in the ground state in its atmosphere were absorbing characteristic narrow regions of the spectrum. This discovery eventually spawned atomic absorption spectrometry, which became a routine technique for chemical analysis in the mid-20th century. Laboratory-based atomic absorption spectrometers differ from the original observation of the Fraunhofer lines because they have always employed a separate light source and atomizer. This article describes a novel atomic absorption device that employs a single source, the tungsten coil, as both the generator of continuum radiation and the atomizer of the analytes. A 25-μL aliquot of sample is placed on the tungsten filament removed from a commercially available 150-W light bulb. The…

Don't used hand raiting and don't used Ai solution