(a)
The battery current just after closing switch S.
(a)
Answer to Problem 102P
The battery current just after closing the switch S is
Explanation of Solution
Given:
The value of emf is
The value of capacitances are
Formula used:
Apply Kirchhoff’s rule in circuit just after switch is closed,
Here,
Calculation:
The equivalent resistance of parallel resistors
From equation (1), the battery current just after closing switch S is calculated as,
Conclusion:
Therefore, the battery current just after closing the switch S is
(b)
The battery current a long time after closing the switch S.
(b)
Answer to Problem 102P
The battery current a long time after closing the switch S is
Explanation of Solution
Formula used:
Apply Kirchhoff’s rule in circuit a long time after switch is closed,
Here,
Calculation:
The equivalent resistance of series resistors
From equation (2), the battery current a long time after closing switch S is calculated as,
Conclusion:
Therefore, the battery current a long time after closing the switch S is
(c)
The charges on capacitors plates a long time after closing the switch S.
(c)
Answer to Problem 102P
The charges on capacitors plates a long time after closing the switch S are
Explanation of Solution
Formula used:
Apply Kirchhoff’s rule in circuit containing resistors
Apply Kirchhoff’s rule in circuit containing resistors
The expression for charge on capacitor
The expression for charge on capacitor
Calculation:
From equation (3), the potential difference
From equation (4), the potential difference
The charge on charge on capacitor
The charge on charge on capacitor
Conclusion:
Therefore, the charges on capacitors plates a long time after closing the switch S are
(d)
The charges on capacitors plates a long time after reopening the switch S.
(d)
Answer to Problem 102P
The charges on capacitors plates a long time after reopening the switch S is zero.
Explanation of Solution
Calculation:
If the switch S is reopened, then after long time there will not be any flow of current in the circuit. Thus,
The potential difference across
The charges on
Conclusion:
Therefore, the charges on capacitors plates a long time after reopening the switch S is zero.
Want to see more full solutions like this?
Chapter 25 Solutions
Physics for Scientists and Engineers
- In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?arrow_forwardThe emf of a good car 12 V battery is 12.8 V. When it is starting the car, it sources 90 A and the terminal voltage drops to 11 V. Calculate the heat (in terms of joule) that is generated in the battery if it takes 1 second to start the car.arrow_forwardConsider the circuit shown in the figure below, where C, - 8.00 uF, C, - 8.00 uF, and AV = 22.0 V. Capacitor C, is first charged by closing switch S,. Switch S, is then opened, and the charged capacitor is connected to the uncharged capacitor by closing S AV (a) Calculate the initial charge (in pC) acquired by C (Round your answer to at least one decimal place.) (b) Calculate the final charge (in uC) on each capacitor. (Round your answers to at least the nearest integer) (c) What 17 After a very long time, switch S, is also closed. By what amount does the charge on the second capacitor change after 5, has been closed for a very long time? (Give your answer in uC.)arrow_forward
- in the curcuit shown in the figure , the S switch is closed at t = 0 and the capacitors, which are completely empty, begin to fill. Here E = 20 V , C = 4uF and R = 30 ohm. a) what is the time constant of the circuit , T in units of microseconds? b)when t=T , what is the total charge , in units of microcloumb accumulated in the capacitors ?arrow_forwardThree capacitors with capacitances of 5 microfarad, 10 microfarad, and 15 microfarad are connected in parallel. (a) Find the capacitance of the combination. (b) If they are connected to a battery of an EMF of 240 V, find the charge in each capacitor.arrow_forwardA capacitor has an initial charge of 10 µC. It is observed that after discharging for 2ms through a resistor of 8.7 kn, the charge of the capacitor is now only 8.1 μC. What is the capacitance of the capacitor? Express your answer in micro Farad, and keep three significant digits. Answer:arrow_forward
- The question is . A) What is the time constant for the circuit shown in the figure below if the value of of e=12.0 V, R=22.8ohm, and C= 88.1mF. B Suppose the switch is closed and the capacitor starts to charge. How much of the charge will be accumulated on each plate of the capacitor after 3 s of charging.. Submit answer the value of the charge (in mC, with two decimal places).arrow_forwardIn the circuit shown switch S has been closed 60 0 for a long time. a) Find the charge in the capacitor b) The switch is now open how long will it take to deplete 90% of the capacitors charge? (Ans. 80 µC, 0.23 ms) 10 0 100V_ 40Q 2 uF Iarrow_forwardPlz do it asaparrow_forward
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegePhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning