The correct readings of rod which are necessary on the batter board tops to set them properly. 5.61 f t Given: Floor elevation 1069.31 f t Benchmark A = 1070.58 f t Sight A = 5.34 f t Concept Used: This is one more method of layout of buildings, is to stake two points on the building, one of them with the total station instrument, take a backsight on the other and stack all the remaining points from that setup using pre -calculated angles and distances. Calculation: Calculate the height of instrument by adding bench mark A and sight A : H I = 1070.58 + 5.34 H I = 1075.92 f t Calculate the elevation value for batter roads by using the formula: E b = F l o o r e l e v a t i o n + 1 f t E b = 1069.31 + 1 E b = 1070.31 f t Now, we must determine the rod reading value at the batter rods by: S b b = E b − H I S b b = 1070.31 − 1075.92 S b b = − 5.61 f t Conclusion: Therefore, the rod readings are necessary on the batter board tops to set them properly is 5.61 f t .

Question

Want to see the full answer?

Answer 1

Question

Chapter 23, Problem 23.18P

To determine

The correct readings of rod which are necessary on the batter board tops to set them properly.

5.61ft

Given:

Floor elevation 1069.31ft

Benchmark A=1070.58ft

Sight A=5.34ft

Concept Used:

This is one more method of layout of buildings, is to stake two points on the building, one of them with the total station instrument, take a backsight on the other and stack all the remaining points from that setup using pre -calculated angles and distances.

Calculation:

Calculate the height of instrument by adding bench mark A and sight A :

HI=1070.58+5.34HI=1075.92ft

Calculate the elevation value for batter roads by using the formula:

Eb=Floor elevation+1 ftEb=1069.31+1Eb=1070.31ft

Now, we must determine the rod reading value at the batter rods by:

Sbb=Eb−HISbb=1070.31−1075.92Sbb=−5.61ft

Conclusion:

Therefore, the rod readings are necessary on the batter board tops to set them properly is 5.61ft .

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Computation must be completeFor the given cantilever beam shown in the figure below,a. Draw the shear and moment diagram using service loads.b. Determine the critical design moment using Working Stress Design (Ma) load combinations.c. Draw the shear and moment diagram using factored loads.d. Determine the critical design moment using Strength Design (Mu) load combinations, use NSCP2015.e. For the given cross-section of the beam, give the reason why the reinforcement is at the topportion of the beam section?

LAB: FORCE AND FORCE-RELATED VARIABLES ASSIGNMENT INSTRUCTIONS INSTRUCTIONS Lab assignments are intended to give you some ‘hands on' experience in applying the concepts introduced in the course text. They are designed to get you out of your classroom or office and develop the skills of designing experiments and collecting data, and then performing calculations, evaluating the results, and communicating your findings. Labs are more than just number crunching - they are about reflecting on what is both practical and technically sound engineering problem-solving. For each problem below, address the scenario presented and develop engineering solutions. Communicate your results using drawings, pictures, and discussion, supported by calculations developed using the Microsoft Equation Editor or similar tool. Submit your lab report in a single pdf file uploaded to the location provided in Canvas before the due date/time indicated. Each problem should be treated as a micro-report with a problem…

How can a construction estimator gain experience to better judge appropriate contingency amounts?