Concept explainers
Two balls, A and B, are released simultaneously from rest at the left end of the equal-length tracks, as shown.
(a) Which ball will reach the end of its track first?
(b) Does ball B roll faster along the lower part of track B than ball A rolls along track A?
(c) Is the speed gained by ball B going down the extra dip the same as the speed it loses going up near the right-hand end? Does this mean that the speeds of balls A and B will be the same at the ends of the tracks?
(d) So, overall, does ball A or ball B have the greater average speed? (Do you wish to change your answer to (a)?
Want to see the full answer?
Check out a sample textbook solutionChapter 2 Solutions
CONCEPTUAL INTEGRATED SCIENCE (PEARSON+
Additional Science Textbook Solutions
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
Chemistry: An Introduction to General, Organic, and Biological Chemistry (13th Edition)
Introductory Chemistry (6th Edition)
Chemistry (7th Edition)
College Physics: A Strategic Approach (3rd Edition)
Microbiology: An Introduction
- A construction worker pulls a five-meter plank up the side of a building under construction by means of a rope tied to one end of the plank (see figure). Assume the opposite end of the plank follows a path perpendicular to the wall of the building and the worker pulls the rope at a rate of 0.14 meter per second. How fast is the end of the plank sliding along the ground when it is 1.8 meters from the wall of the building? (Round your answer to two decimal places.) 5 m m/sec Need Help? Watch It Additional Materialsarrow_forwardThe illustration below shows a ball on a curved track. The ball starts with zero velocity at the top of the track. It then rolls from the top of the track to the horizontal part at the ground. Ignoring friction, its velocity just at the moment it reaches the ground is 15 m/s. What is the height, h, from the ground to the top of the track? _marrow_forwardYou are coasting along on your bike (that has a 0.66 m diameter tire), You notice a twig in your spoke (at 1/2 the radius of the tire) hits the bike frame once per second. What is your speed in m/s?arrow_forward
- As part of an experiment, Bob and robert build two inclines that have the same height but make different angles with the perfectly horizontal ground. They roll the same steel ball down each incline. On which incline will the speed of the ball at the bottom be the greater? Will the steel ball take longer to get to the bottom of the inclines?arrow_forwardA marble rolls off the edge of a 1.2 meter high table with an initial speed of 0.5 m/s. a) how long does it take for the marble to hit the floor? b) how far from the table will it hit the floor?arrow_forwardJupiter's moon Io has active volcanoes (in fact, it is the most volcanically active body in the solar system) that eject material as high as 500 km (or even higher) above the surface. Io has a mass of 8.93×1022kg and a radius of 1821 km How high would this material go on earth if it were ejected with the same speed as on Io? (REarth = 6370 km, mEartg=5.96×1024kg) NOTE: Your answer suggests that you have assumed constant gravitational acceleration over the whole height of the ejected debris. Note that the gravitational field changes quite significantly over this height.arrow_forward
- The "Giant Swing" at a county fair consists of a vertical central shaft with a number of horizontal arms attached at its upper end. (See the figure below (Figure 1)) Each arm supports a seat suspended from a 5.00 m -long cable, the upper end of which is fastened to the arm. Take R = 2.00 m. Figure Part A R- 5.00 m > 1 of 1 > Find the time of one revolution of the swing if the cable supporting the seat makes an angle of 0 = 26.0° with the vertical. Ο ΑΣΦ t = 6.42 ? S You have already submitted this answer. Enter a new answer. No credit lost. Try again.arrow_forwardWhat is the velocity of Jupiter if an object on the equator of Jupiter would travel approximately 280,000 miles in about 10 hours?arrow_forwardAt what rate must a cylindrical spaceship rotate if occupants are to experience simulated gravity of 0.52 gg? Assume the spaceship's diameter is 29 mm , and give your answer as the time needed for one revolution (see the figure (Figure 1)). Express your answer using three significant figures and include the appropriate units.arrow_forward
- You throw a ball to the sky to check the dynamics of its speed. When the ball is going up, its speed is decreasing as the gravitational force is working downwards. However, after some time, the ball will reach the pick position and will start coming back to the ground. At this moment, the speed of the ball will be increasing with time. What would happen to its acceleration?arrow_forwardis negligibly small and g = 9.80 m/s? A)0.109 s B) 0.282 s C) 0.218 s D) 0.441 s Answer: owanA batongi od dra o )A cannonball is fired from a castle with the trajectory as shown in the figure. The initial ( velocity components are 180 m/s (horizontal) and 92 m/s (vertical). The cannonball reaches maximum height at point H and then hits the ground target at point G. What is the height between H and G without considering air resistance? H 30° 20m 20M A) 108 m C) 45,000 m E) 236 m B) 128 m D) 216 m Answer: 60 m/s at an angle 30° above the horizontal. Whatarrow_forwardAn extrasolar planet has a mass of eight times that of the Earth and radius of twice that of the Earth? What is the escape velocity of the planet if the escape velocity of the Earth is 11.2 km/sec? An object with a mass of 100 kg measured on Earth is taken to the Mars. What is the mass of the object on the Mars’s surface if the acceleration due to gravity on Mars is two-fifth of that on Earth?arrow_forward
- Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning