The measurement of length at different temperature.

Question

Want to see more full solutions like this?

Answer 1

Question

Chapter 19, Problem 1OQ

To determine

The measurement of length at different temperature.

Expert Solution & Answer

Answer to Problem 1OQ

Option (b) too short.

Explanation of Solution

The length is changing with temperature. Here, the measurement of length during 22°C will be different than that at 27°C.

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short.

Conclusion:

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short. Thus, option (b) is correct.

Since, the measured length with the heated steel tape will be too short. Thus, option (a) is incorrect.

At different temperature the measured length is different Thus, option (c) is incorrect.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Students have asked these similar questions

••63 SSM www In the circuit of Fig. 27-65, 8 = 1.2 kV, C = 6.5 µF, R₁ S R₂ R3 800 C H R₁ = R₂ = R3 = 0.73 MQ. With C completely uncharged, switch S is suddenly closed (at t = 0). At t = 0, what are (a) current i̟ in resistor 1, (b) current 2 in resistor 2, and (c) current i3 in resistor 3? At t = ∞o (that is, after many time constants), what are (d) i₁, (e) i₂, and (f) iz? What is the potential difference V2 across resistor 2 at (g) t = 0 and (h) t = ∞o? (i) Sketch V2 versus t between these two extreme times. Figure 27-65 Problem 63.

Thor flies by spinning his hammer really fast from a leather strap at the end of the handle, letting go, then grabbing it and having it pull him. If Thor wants to reach escape velocity (velocity needed to leave Earth’s atmosphere), he will need the linear velocity of the center of mass of the hammer to be 11,200 m/s. Thor's escape velocity is 33532.9 rad/s, the angular velocity is 8055.5 rad/s^2. While the hammer is spinning at its maximum speed what impossibly large tension does the leather strap, which the hammer is spinning by, exert when the hammer is at its lowest point? the hammer has a total mass of 20.0kg.

If the room’s radius is 16.2 m, at what minimum linear speed does Quicksilver need to run to stay on the walls without sliding down? Assume the coefficient of friction between Quicksilver and the wall is 0.236.

Answer 2

Question

Chapter 19, Problem 1OQ

To determine

The measurement of length at different temperature.

Expert Solution & Answer

Answer to Problem 1OQ

Option (b) too short.

Explanation of Solution

The length is changing with temperature. Here, the measurement of length during 22°C will be different than that at 27°C.

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short.

Conclusion:

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short. Thus, option (b) is correct.

Since, the measured length with the heated steel tape will be too short. Thus, option (a) is incorrect.

At different temperature the measured length is different Thus, option (c) is incorrect.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 3

Question

Chapter 19, Problem 1OQ

To determine

The measurement of length at different temperature.

Expert Solution & Answer

Answer to Problem 1OQ

Option (b) too short.

Explanation of Solution

The length is changing with temperature. Here, the measurement of length during 22°C will be different than that at 27°C.

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short.

Conclusion:

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short. Thus, option (b) is correct.

Since, the measured length with the heated steel tape will be too short. Thus, option (a) is incorrect.

At different temperature the measured length is different Thus, option (c) is incorrect.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 4

Question

Chapter 19, Problem 1OQ

To determine

The measurement of length at different temperature.

Expert Solution & Answer

Answer to Problem 1OQ

Option (b) too short.

Explanation of Solution

The length is changing with temperature. Here, the measurement of length during 22°C will be different than that at 27°C.

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short.

Conclusion:

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short. Thus, option (b) is correct.

Since, the measured length with the heated steel tape will be too short. Thus, option (a) is incorrect.

At different temperature the measured length is different Thus, option (c) is incorrect.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 5

Chapter 19, Problem 1OQ

To determine

The measurement of length at different temperature.

Expert Solution & Answer

Answer to Problem 1OQ

Option (b) too short.

Explanation of Solution

The length is changing with temperature. Here, the measurement of length during 22°C will be different than that at 27°C.

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short.

Conclusion:

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short. Thus, option (b) is correct.

Since, the measured length with the heated steel tape will be too short. Thus, option (a) is incorrect.

At different temperature the measured length is different Thus, option (c) is incorrect.

Answer 6

Chapter 19, Problem 1OQ

To determine

The measurement of length at different temperature.

Expert Solution & Answer

Answer to Problem 1OQ

Option (b) too short.

Explanation of Solution

The length is changing with temperature. Here, the measurement of length during 22°C will be different than that at 27°C.

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short.

Conclusion:

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short. Thus, option (b) is correct.

Since, the measured length with the heated steel tape will be too short. Thus, option (a) is incorrect.

At different temperature the measured length is different Thus, option (c) is incorrect.

Answer 7

Chapter 19, Problem 1OQ

To determine

The measurement of length at different temperature.

Answer 8

Expert Solution & Answer

Answer to Problem 1OQ

Option (b) too short.

Answer 9

Expert Solution & Answer

Answer 10

Expert Solution & Answer

Answer 11

Explanation of Solution

The length is changing with temperature. Here, the measurement of length during 22°C will be different than that at 27°C.

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short.

Conclusion:

Since, the object has smaller linear expansion coefficient than steel, the length measured with the heated steel tape will be too short. Thus, option (b) is correct.

Since, the measured length with the heated steel tape will be too short. Thus, option (a) is incorrect.

At different temperature the measured length is different Thus, option (c) is incorrect.