Set: In C++, a associative container which is used to store the unique values is referred as “set”. A “set” container can be implemented using the STL (Standard Template Library) class “set” template. The importance of set are discussed as follow as: “set” elements must be “unique”, which means two elements in a “set” cannot have same values. Value of the element in a set cannot be modified, but they can be inserted or removed. “set” elements are automatically sorted in ascending order. Syntax: set<datatype> set_Name = {values}; Where, “set_Name” is the object name.

Question

Want to see the full answer?

Answer 1

Question

Chapter 17.5, Problem 17.30CP

Program Plan Intro

Set:

In C++, a associative container which is used to store the unique values is referred as “set”.

A “set” container can be implemented using the STL (Standard Template Library) class “set” template. The importance of set are discussed as follow as:

“set” elements must be “unique”, which means two elements in a “set” cannot have same values.

Value of the element in a set cannot be modified, but they can be inserted or removed.

“set” elements are automatically sorted in ascending order.

Syntax:

set<datatype> set_Name = {values};

Where, “set_Name” is the object name.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

15 points Save ARS Consider the following scenario in which host 10.0.0.1 is communicating with an external SMTP mail server at IP address 128.119.40.186. NAT translation table WAN side addr LAN side addr (c), 5051 (d), 3031 S: (e),5051 SMTP B D (f.(g) 10.0.0.4 server 138.76.29.7 128.119.40.186 (a) is the source IP address at A, and its value. S: (a),3031 D: (b), 25 10.0.0.1 A 10.0.0.2. 1. 138.76.29.7 10.0.0.3

6.3A-3. Multiple Access protocols (3). Consider the figure below, which shows the arrival of 6 messages for transmission at different multiple access wireless nodes at times t=0.1, 1.4, 1.8, 3.2, 3.3, 4.1. Each transmission requires exactly one time unit. 1 t=0.0 2 3 45 t=1.0 t-2.0 t-3.0 6 t=4.0 t-5.0 For the CSMA protocol (without collision detection), indicate which packets are successfully transmitted. You should assume that it takes .2 time units for a signal to propagate from one node to each of the other nodes. You can assume that if a packet experiences a collision or senses the channel busy, then that node will not attempt a retransmission of that packet until sometime after t=5. Hint: consider propagation times carefully here. (Note: You can find more examples of problems similar to this here B.] ☐ U ப 5 - 3 1 4 6 2

Just wanted to know, if you had a scene graph, how do you get multiple components from a specific scene node within a scene graph? Like if I wanted to get a component from wheel from the scene graph, does that require traversing still? Like if a physics component requires a transform component and these two component are part of the same scene node. How does the physics component knows how to get the scene object's transform it is attached to, this being in a scene graph?