The processes and materials required for manufacturing of fiber reinforced fiberglass composite needs to be explained. Concept Introduction: Fiber reinforced components (FRC) − It consist of the following three components − The fiber − available as either dispersed or discontinuous phase The matrix − presence as continuous phase The interface − presence as fine interphase Same stress is observed when the direction of matrix and direction of fiber are aligned in parallel direction to each other. These techniques use the following methods for the formation of high strength fiber composite. Methods − Refining and blending Fiberglass −It uses glass fiber for its formation. It is a common type of fiber reinforced plastic Properties of Fiberglass − Non-magnetic Non-Conductive in nature High weight Cheap in cost More flexible as compared to copper

Question

Want to see the full answer?

Answer 1

Question

Chapter 17, Problem 17.58DP

Interpretation Introduction

Interpretation:

The processes and materials required for manufacturing of fiber reinforced fiberglass composite needs to be explained.

Concept Introduction:

Fiber reinforced components (FRC) −

It consist of the following three components −

The fiber − available as either dispersed or discontinuous phase

The matrix − presence as continuous phase

The interface − presence as fine interphase

Same stress is observed when the direction of matrix and direction of fiber are aligned in parallel direction to each other. These techniques use the following methods for the formation of high strength fiber composite.

Methods − Refining and blending

Fiberglass −It uses glass fiber for its formation. It is a common type of fiber reinforced plastic

Properties of Fiberglass −

Non-magnetic

Non-Conductive in nature

High weight

Cheap in cost

More flexible as compared to copper

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

2-7 The force P applied at joint D of the square frame causes the frame to sway and form the dashed rhombus. Determine the average normal strain developed in wire AC. Assume the three rods are rigid. I understand how you calculate length LAC its just the sqrt(400^2+400^2) = 565.685mm. I do understand that you have to take LAC'-LAC/LAC to get .0258mm/mm. I'm just not understanding the cosine law used to calculate LAC'. I guess what I'm asking is why do you use cos instead of sin or tangent? I've been trying to understand why that was used for a bit now and it's probably something simple I'm forgetting. If you can, please clarify it in detail. Thank you so much!

The Mach number NM for flow of a perfect gas in a pipe depends upon the specific-heat ratio k (dimensionless), the pressure p, the density ρ, and the velocity V. Obtain by dimensional reasoning the form of the Mach number expression. (Buckingham pi)Answer: NM = f(V/sqrt(p/ρ), k)

Assume the Link AO is the input and revolves 360°, determine a. the coordinates of limit positions of point B, b. the angles  (AOC) corresponding to the limit positions