Starting Out with Programming Logic and Design (4th Edition)
Starting Out with Programming Logic and Design (4th Edition)
4th Edition
ISBN: 9780133985078
Author: Tony Gaddis
Publisher: PEARSON
Expert Solution & Answer
Book Icon
Chapter 15.1, Problem 15.3CP

Explanation of Solution

Command-line user interfaces:

  • The user and computer interact with one another using the commands or through program code.
  • The command line interface was the popular before the introduction of the GUI (Graphical user Interface).
  • When a command is typed to interact with the computer it is called as “command Line interface”.
  • The usage of commands in interacting with the computer requires user to know basic syntax knowledge on how the command needs to be typed such that the computer will respond accordingly.
  • It will be little difficult for the beginner level user to properly learn the syntax of the commands.
  • The commands are entered in the prompt screen for its execution.

Order of execution in command Line Interface:

The order of execution in command line interface or in text based environment is determined by the program...

Blurred answer
Students have asked these similar questions
15 points Save ARS Consider the following scenario in which host 10.0.0.1 is communicating with an external SMTP mail server at IP address 128.119.40.186. NAT translation table WAN side addr LAN side addr (c), 5051 (d), 3031 S: (e),5051 SMTP B D (f.(g) 10.0.0.4 server 138.76.29.7 128.119.40.186 (a) is the source IP address at A, and its value. S: (a),3031 D: (b), 25 10.0.0.1 A 10.0.0.2. 1. 138.76.29.7 10.0.0.3
6.3A-3. Multiple Access protocols (3). Consider the figure below, which shows the arrival of 6 messages for transmission at different multiple access wireless nodes at times t=0.1, 1.4, 1.8, 3.2, 3.3, 4.1. Each transmission requires exactly one time unit. 1 t=0.0 2 3 45 t=1.0 t-2.0 t-3.0 6 t=4.0 t-5.0 For the CSMA protocol (without collision detection), indicate which packets are successfully transmitted. You should assume that it takes .2 time units for a signal to propagate from one node to each of the other nodes. You can assume that if a packet experiences a collision or senses the channel busy, then that node will not attempt a retransmission of that packet until sometime after t=5. Hint: consider propagation times carefully here. (Note: You can find more examples of problems similar to this here B.] ☐ U ப 5 - 3 1 4 6 2
Just wanted to know, if you had a scene graph, how do you get multiple components from a specific scene node within a scene graph? Like if I wanted to get a component from wheel from the scene graph, does that require traversing still?   Like if a physics component requires a transform component and these two component are part of the same scene node. How does the physics component knows how to get the scene object's transform it is attached to, this being in a scene graph?

Chapter 15 Solutions

Starting Out with Programming Logic and Design (4th Edition)

Knowledge Booster
Background pattern image
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Programming with Microsoft Visual Basic 2017
Computer Science
ISBN:9781337102124
Author:Diane Zak
Publisher:Cengage Learning
Text book image
Enhanced Discovering Computers 2017 (Shelly Cashm...
Computer Science
ISBN:9781305657458
Author:Misty E. Vermaat, Susan L. Sebok, Steven M. Freund, Mark Frydenberg, Jennifer T. Campbell
Publisher:Cengage Learning