An essay about the replacement of metallic components by polymers and composite materials and answer the following: 1. Which automotive components are replaced with the polymers and composites? 2. Specify the materials that are being used. 3. Give the reasons for these replacements.

Question

Want to see the full answer?

Answer 1

Question

Chapter 15, Problem 3DP

To determine

To write:

An essay about the replacement of metallic components by polymers and composite materials and answer the following:

1. Which automotive components are replaced with the polymers and composites?

2. Specify the materials that are being used.

3. Give the reasons for these replacements.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Hi, can you please define and calculate the failure mode of the linkage that failed on the swing (images added) : A child swing set was discovered to have failed at the fixing at the top of the chains connecting the seat to the top of the swing set. A 12 mm threaded steel bolt, connecting the shackle to the top beam, failed at the start of the threaded region on the linkage closest to the outside side of the swing set . The linkage and bolts were made of electro galvanised mild steel . The rigid bar chain alternatives and fixings were of the same material and appeared to be fitted in accordance with guidelines. The yield strength of the steel used is 260 MPa and the UTS is 380 MPa. The bolt that failed was threaded using a standard thread with a pitch (distance between threads) of 1.75 mm and a depth of approximately 1.1 mm. The swing set in question had been assigned to ‘toddlers’ with the application of a caged-type seat. However, the location was within the play area not…

E. coli was continuously cultured in a continuous stirred tank fermenter with a working volume of 1 L by chemostat. A medium containing 4.0 g/L of glucose as a carbon source was fed to the fermenter at a constant flow rate of 0.5 L/hr, and the glucose concentration in the output stream was 0.20 g/L. The cell yield with respect to glucose was 0.42 g dry cells per gram glucose.

what is admixture and what are the characteristics of it explain in detail