When a block of mass M , connected to the end of a spring of mass m s = 7.40 g and force constant k , is set into simple harmonic motion , the period of its motion is T = 2 π M + ( m s / 3 ) k A two-part experiment is conducted with the use of blocks of various masses suspended vertically from the spring as shown in Figure P15.76. (a) Static extensions of 17.0, 29.3, 35.3, 41.3, 47.1, and 49.3 cm are measured for M values of 20.0, 40.0, 50.0, 60.0, 70.0, and 80.0 g, respectively. Construct a graph of Mg versus x and perform a linear least-squares fit to the data. (b) From the slope of your graph, determine a value for k for this spring. (c) The system is now set into simple harmonic motion, and periods are measured with a stopwatch. With M = 80.0 g, the total time interval required for ten oscillations is measured to be 13.41 s. The experiment is repeated with M values of 70.0, 60.0, 50.0, 40.0, and 20.0 g, with corresponding time intervals for ten oscillations of 12.52, 11.67, 10.67, 9.62, and 7.03 s. Make a table of these masses and times. (d) Compute the experimental value for T from each of these measurements. (e) Plot a graph of T 2 versus M and (f) determine a value for k from the slope of the linear least-squares fit through the data points. (g) Compare this value of k with that obtained in part (b). (h) Obtain a value for m s from your graph and compare it with the given value of 7.40 g.
When a block of mass M , connected to the end of a spring of mass m s = 7.40 g and force constant k , is set into simple harmonic motion , the period of its motion is T = 2 π M + ( m s / 3 ) k A two-part experiment is conducted with the use of blocks of various masses suspended vertically from the spring as shown in Figure P15.76. (a) Static extensions of 17.0, 29.3, 35.3, 41.3, 47.1, and 49.3 cm are measured for M values of 20.0, 40.0, 50.0, 60.0, 70.0, and 80.0 g, respectively. Construct a graph of Mg versus x and perform a linear least-squares fit to the data. (b) From the slope of your graph, determine a value for k for this spring. (c) The system is now set into simple harmonic motion, and periods are measured with a stopwatch. With M = 80.0 g, the total time interval required for ten oscillations is measured to be 13.41 s. The experiment is repeated with M values of 70.0, 60.0, 50.0, 40.0, and 20.0 g, with corresponding time intervals for ten oscillations of 12.52, 11.67, 10.67, 9.62, and 7.03 s. Make a table of these masses and times. (d) Compute the experimental value for T from each of these measurements. (e) Plot a graph of T 2 versus M and (f) determine a value for k from the slope of the linear least-squares fit through the data points. (g) Compare this value of k with that obtained in part (b). (h) Obtain a value for m s from your graph and compare it with the given value of 7.40 g.
When a block of mass M, connected to the end of a spring of mass ms = 7.40 g and force constant k, is set into simple harmonic motion, the period of its motion is
T
=
2
π
M
+
(
m
s
/
3
)
k
A two-part experiment is conducted with the use of blocks of various masses suspended vertically from the spring as shown in Figure P15.76. (a) Static extensions of 17.0, 29.3, 35.3, 41.3, 47.1, and 49.3 cm are measured for M values of 20.0, 40.0, 50.0, 60.0, 70.0, and 80.0 g, respectively. Construct a graph of Mg versus x and perform a linear least-squares fit to the data. (b) From the slope of your graph, determine a value for k for this spring. (c) The system is now set into simple harmonic motion, and periods are measured with a stopwatch. With M = 80.0 g, the total time interval required for ten oscillations is measured to be 13.41 s. The experiment is repeated with M values of 70.0, 60.0, 50.0, 40.0, and 20.0 g, with corresponding time intervals for ten oscillations of 12.52, 11.67, 10.67, 9.62, and 7.03 s. Make a table of these masses and times. (d) Compute the experimental value for T from each of these measurements. (e) Plot a graph of T2 versus M and (f) determine a value for k from the slope of the linear least-squares fit through the data points. (g) Compare this value of k with that obtained in part (b). (h) Obtain a value for ms from your graph and compare it with the given value of 7.40 g.
Definition Definition Special type of oscillation where the force of restoration is directly proportional to the displacement of the object from its mean or initial position. If an object is in motion such that the acceleration of the object is directly proportional to its displacement (which helps the moving object return to its resting position) then the object is said to undergo a simple harmonic motion. An object undergoing SHM always moves like a wave.
(a)
Expert Solution
To determine
To draw: The graph of
Mg versus
x and perform the linear least- square fit to the data.
Answer to Problem 15.76AP
The graph of
Mg versus
x is,
Explanation of Solution
Given info: The block of mass is
M, the mass of spring is
7.40g and the force constant is
k.
The values of mass and the static extension are given and calculate the value of the
Mg.
Static extension (x) in
m
Mass (M) in
kg
Weight
(Mg) in
N
0.17
0.02
0.196
0.293
0.04
0.392
0.353
0.05
0.49
0.413
0.06
0.588
0.471
0.07
0.686
0.493
0.08
0.784
Table (1)
Conclusion:
The table (1) indicates the values required to plot the graph of
Mg versus
x.
Figure (1)
(b)
Expert Solution
To determine
The value of
k for spring using the slope of graph.
Answer to Problem 15.76AP
The value of
k for spring using the slope of graph is
1.7386N/m.
Explanation of Solution
Given info: The block of mass is
M, the mass of spring is
7.40g and the force constant is
k.
The equation of the graph is,
y=1.7386x−0.1128
The slope intercept form of the equation of the line is,
y=mx+c
Here,
m is the slope.
c is the intercept.
Compare equation (1) and (2).
m=1.7386
Since the slope of the graph indicates the force constant of the spring.
k=1.7386N/m
Conclusion:
Therefore, the value of
k for spring using the slope of graph is
1.7386N/m.
(c)
Expert Solution
To determine
To draw: The table of given masses and the times.
Answer to Problem 15.76AP
The table of given masses and the times is,
Mass in
g
Time intervals in
s.
20
7.03
40
9.62
50
10.67
60
11.67
70
12.52
80
13.41
Explanation of Solution
Given info: The block of mass is
M, the mass of spring is
7.40g and the force constant is
k.
The values of mass and the static extension are given and calculate the value of the
Mg.
Mass in
g
Time intervals in
s.
20
7.03
40
9.62
50
10.67
60
11.67
70
12.52
80
13.41
Table (2)
Conclusion:
The table (1) indicates the values of mass and the time intervals.
(d)
Expert Solution
To determine
The experimental value for
T from each of the measurements.
Answer to Problem 15.76AP
The experimental values for
T from each of the measurements are
0.703s,
0.962s,
1.067s,
1.167s,
1.252s and
1.341s.
Explanation of Solution
Given info: The block of mass is
M, the mass of spring is
7.40g and the force constant is
k.
The expression for the time periods for each experiment is,
Tn=Tn
Here,
n is total number of experiments.
The ten experiments are conducted.
Calculate time periods for each experiment.
Total time period
(T) in
s
Time period for one experiment
(Tn=T10s)
7.03
0.703
9.62
0.962
10.67
0.1067
11.67
1.167
12.52
1.252
13.41
1.341
Table (3)
Conclusion:
Therefore, the experimental values for
T from each of the measurements are
0.703s,
0.962s,
1.067s,
1.167s,
1.252s and
1.341s.
(e)
Expert Solution
To determine
To draw: The graph of
T2 versus
M.
Answer to Problem 15.76AP
The graph of
T2 versus
M is,
Explanation of Solution
Given info: The block of mass is
M, the mass of spring is
7.40g and the force constant is
k.
Time period for one experiment
(T) in
s
T2
Mass (M) in
kg
0.703
0.494209
0.02
0.962
0.925444
0.04
0.1067
1.138489
0.05
1.167
1.361889
0.06
1.252
1.567504
0.07
1.341
1.798281
0.08
Table (4)
The table (4) indicates the values required to plot the graph of
T2 versus
M.
Figure (2)
(f)
Expert Solution
To determine
The value of
k for spring using the slope of graph.
Answer to Problem 15.76AP
The value of
k for spring using the slope of graph is
1.82N/m.
Explanation of Solution
Given info: The block of mass is
M, the mass of spring is
7.40g and the force constant is
k.
The equation of the graph is,
y=21.665x+0.0589T2=21.665M+0.0589 (3)
The given expression is,
T=2πM+ms3k
Square both sides in above expression.
T2=4π2kM+4π23kms (4)
Compare equation (3) and (4).
4π2k=21.665k=1.82N/m
Conclusion:
Therefore, the value of
k for spring using the slope of graph is
1.82N/m.
(g)
Expert Solution
To determine
The comparison in value of
k obtained between the part (b) and part (f) of the question.
Answer to Problem 15.76AP
The value of
k obtained in part (b) of the question is less than the value of
k obtained in part (f) of the question.
Explanation of Solution
Given info: The block of mass is
M, the mass of spring is
7.40g and the force constant is
k.
The value of
k obtained in part (b) of the question is,
kb=1.7386N/m
The value of
k obtained in part (f) of the question is,
kf=1.82N/m
Compare the values.
kb<kf1.7386N/m<1.82N/m
Conclusion:
Therefore, the value of
k obtained in part (b) of the question is less than the value of
k obtained in part (f) of the question.
(h)
Expert Solution
To determine
The value of
ms for spring using graph and compare it with
7.40g
Answer to Problem 15.76AP
The value of
ms for spring using graph is
8.14g and it is greater than
7.40g.
Explanation of Solution
Given info: The block of mass is
M, the mass of spring is
7.40g and the force constant is
k.
An aluminum rod and a copper rod have the same length of 100cm at 5C. At what temperatures would one of the rods be 0.5 mm longer than the other? Which rod is longer at such temperature?
ROTATIONAL DYNAMICS
Question 01
A solid circular cylinder and a solid spherical ball of the same mass and radius are rolling
together down the same inclined. Calculate the ratio of their kinetic energy. Assume pure
rolling motion Question 02
A sphere and cylinder of the same mass and radius start from ret at the same point and more
down the same plane inclined at 30° to the horizontal
Which body gets the bottom first and what is its acceleration
b) What angle of inclination of the plane is needed to give the slower body the same
acceleration
Question 03
i)
Define the angular velocity of a rotating body and give its SI unit
A car wheel has its angular velocity changing from 2rads to 30 rads
seconds. If the radius of the wheel is 400mm. calculate
ii)
The angular acceleration
iii)
The tangential linear acceleration of a point on the rim of the wheel
Question 04
in 20
Question B3
Consider the following FLRW spacetime:
t2
ds² = -dt² +
(dx²
+ dy²+ dz²),
t2
where t is a constant.
a)
State whether this universe is spatially open, closed or flat.
[2 marks]
b) Determine the Hubble factor H(t), and represent it in a (roughly drawn) plot as a function
of time t, starting at t = 0.
[3 marks]
c) Taking galaxy A to be located at (x, y, z) = (0,0,0), determine the proper distance to galaxy
B located at (x, y, z) = (L, 0, 0). Determine the recessional velocity of galaxy B with respect
to galaxy A.
d) The Friedmann equations are
2
k
8πG
а
4πG
+
a²
(p+3p).
3
a
3
[5 marks]
Use these equations to determine the energy density p(t) and the pressure p(t) for the
FLRW spacetime specified at the top of the page.
[5 marks]
e) Given the result of question B3.d, state whether the FLRW universe in question is (i)
radiation-dominated, (ii) matter-dominated, (iii) cosmological-constant-dominated, or (iv)
none of the previous. Justify your answer.
f)
[5 marks]
A conformally…
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.