Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 14, Problem 6ASRQ
While bleeding air from a cooling system: Technician A loosens a heater hose at its highest point Technician B uses air bleed valves. Who is correct?
- Technician A
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Coolant hoses are being discussed.
Technician A states that
many
manufacturers
recommend coolant hose replacement on a
maintenance schedule. Technician B states
that coolant hoses can fail prematurely due
to contamination by oil. Who is correct?
Select one:
a. Technician A only
b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
Choose correct answer:
Which one of the following devices creates only flow?
An external gear pumps
Pressure relief valve
Pneumatic compressors
Pressure reducing valve
A 2 inch-diameter horizontal jet of water with a velocity of 20 ft/s relative to
the ground strikes a flat plate that is attached to a car moving at a velocity of
Ve. After it hits, the water splatters in all directions in the plane of the plate.
Investigate the effect of the car velocity V. on the force exerted on the plate.
Chapter 14 Solutions
Automotive Technology
Ch. 14 - What is the most efficient way to increase a...Ch. 14 - Explain why a pressure relief valve is needed in...Ch. 14 - List five problems that can be caused by engine...Ch. 14 - Describe the procedure for using air bleed valves...Ch. 14 - Describe the simple test used to determine whether...Ch. 14 - True or False? The presence of air in the cooling...Ch. 14 - True or False? Oil pressure is determined by...Ch. 14 - True or False? To eliminate the drain of engine...Ch. 14 - Which of the following is a function of the...Ch. 14 - For every pound of pressure put on engine coolant,...
Ch. 14 - Which is not a typical method of driving the water...Ch. 14 - Which of the following is not an effective way to...Ch. 14 - Cooling system hoses should be replaced when they...Ch. 14 - Which of the following is not a true statement...Ch. 14 - An engine overheats in traffic but is fine when...Ch. 14 - Technician A says that excessive engine oil...Ch. 14 - While checking for conditions that might cause...Ch. 14 - When discussing oil consumption: Technician A says...Ch. 14 - Technician A says that if the PCV valve or...Ch. 14 - While bleeding air from a cooling system:...Ch. 14 - While diagnosing an engine that overheats after...Ch. 14 - While performing a cooling system service on a...Ch. 14 - While discussing the causes of extreme engine...Ch. 14 - While diagnosing the cause of air bubbles in the...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Technician A says that some refrigerant leaks can also be traced to pinholes in the evaporator caused by acid, which forms when water and refrigerant mix. Technician B says that leaks are most often found at the compressor hose connections and at the various fittings and joints in the system. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardTechnician A says that the presence of oil around a fitting of an air-conditioning line may indicate an oil leak but not a refrigerant leak. Technician B says that using an electronic leak detector is the best way to find the source of a refrigerant leak. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardTrue or False: All gas valves snap open and closed.arrow_forward
- True or False: Turbulence in airflow causes friction drop.arrow_forwardA technician is inspecting a vehicle and finds the upper radiator hose is collapsed, and the cooling system pulled into a vacuum when cold. Technician A states that a leak in the surge tank could be the cause. Technician B states that the radiator cap is most likely defective. Who is correct? Select one: a. Technician A only b. Technician B only c. Both Technicians A and B d. Neither Technician A nor Barrow_forwardWhich of the following statements is not true? A direct acting PRV: Is complex in construction, therefore can malfunction if a very small dirt gets trapped inside the valve, which may result in safety hazard Offers uneven flow Does not provide precise pressure control Causes more wastage of HP compared to a compound one Which of the following basic system components has the primary function of removing the heat of compression from the air? Receiver Relief valve Pressure regulator Dryer Aftercooler Which of the following statements is true? A single acting cylinder may have two ports at two different ends and pressurized fluid can be directed to both of them A single acting cylinder with two ports will can be used as a double acting cylinder A single acting cylinder may have two ports at two different ends but into only one of the ports pressurized fluid is being directed A single acting cylinder…arrow_forward
- Technician A says that if the PCV valve or connecting hoses become clogged, excessive pressure will develop in the crankcase and can cause oil leaks. Technician B says that if the PCV valve or connecting hoses become clogged, oil may be pushed into the air cleaner or cause it to be drawn into the intake manifold. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardTrue or False? Oil pressure is determined by whether the pump is a gear type or rotor type and by oil clearances, the pumps pressure regulator valve, and oil viscosity.arrow_forwardTechnician A says it is not necessary to measure valve stem height unless the valves have been replaced. Technician B says valve stem height can be adjusted with shims. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- Technician A says that evacuating (pumping down) an air-conditioning system removes air and moisture from the system. Technician B says that evacuating (pumping down) an air-conditioning system removes dirt particles from the system. Who is correct? Technician A only Technician B only Both A and B Neither A nor Barrow_forwardThe presents of air in the cooling systems indicates the head gasket is faulty? True or falsearrow_forwardTrue or false The flexible duct system provides the lowest air resistance.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Welding: Principles and Applications (MindTap Cou...Mechanical EngineeringISBN:9781305494695Author:Larry JeffusPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Welding: Principles and Applications (MindTap Cou...
Mechanical Engineering
ISBN:9781305494695
Author:Larry Jeffus
Publisher:Cengage Learning
Hydronics Step by Step; Author: Taco Comfort Solutions;https://www.youtube.com/watch?v=-XGNl9kppR8;License: Standard Youtube License